Difficulty
Easy
Steps
9
Time Required
10 - 15 minutes
Sections
1
- Media Display System
- 9 steps
Flags
0
BackNissan Versa
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Media Display System
- Ensure that the car is turned off.
Ensure that the car is turned off.
1024
Step 2
- Pull on the switch for indoor/outdoor air to remove it.
Pull on the switch for indoor/outdoor air to remove it.
Step 3
- Use a spudger (or an old credit card) to gently pry the front panel away from the rest of the dash.
- After wedging the parts apart you will see a gap.
Use a spudger (or an old credit card) to gently pry the front panel away from the rest of the dash.
After wedging the parts apart you will see a gap.
Step 4
- Using your fingers, start from the top of the panel and move down on either side to pry the panel open.
Using your fingers, start from the top of the panel and move down on either side to pry the panel open.
Step 5
- Once the panel is free from the dash, flip it over to expose the cables connected to it.
Once the panel is free from the dash, flip it over to expose the cables connected to it.
Step 6
- Remove the top cable by simply squeezing the end and pulling it out of its socket.
- Use a spudger to push down on the tab of the bottom cable and remove it.
Remove the top cable by simply squeezing the end and pulling it out of its socket.
Use a spudger to push down on the tab of the bottom cable and remove it.
Step 7
- The front panel is now completely free from the dash and can be set aside.
- Using a Phillips #3 screwdriver, remove the two screws on either side of the media system.
The front panel is now completely free from the dash and can be set aside.
Using a Phillips #3 screwdriver, remove the two screws on either side of the media system.
Step 8
- Carefully pull out the media system and turn it over so that the cables on its rear are visible.
- Use your hands to pinch the tabs and gently pull out each cable.
Carefully pull out the media system and turn it over so that the cables on its rear are visible.
Use your hands to pinch the tabs and gently pull out each cable.
Step 9
- Now the media system is completely free from the car.
- Using a T10 Torx screwdriver, unscrew the four screws on either side of the media system.
Now the media system is completely free from the car.
Using a T10 Torx screwdriver, unscrew the four screws on either side of the media system.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Matthew do Santos-Zounon
Member since: 09/16/2020
193 Reputation
1 Guide authored
Badges:
3
Team
York University, Team S2-G5, Melo-Thaiss Fall 2020
Member of York University, Team S2-G5, Melo-Thaiss Fall 2020
YORK-MELO-THAISS-F20S2G5
1 Member
1 Guide authored