Difficulty

Easy

Steps

5

Time Required

                          10 minutes

Sections

2

  • Battery
  • 2 steps
  • ZL and ZR Buttons
  • 3 steps

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

  • BackNintendo Wii U Pro Controller

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Turn the controller over to reveal the battery cover.
  • Use the J000 screwdriver to remove the screw that secures the battery cover.

Turn the controller over to reveal the battery cover.

Use the J000 screwdriver to remove the screw that secures the battery cover.

1024

Step 2

  • Remove the battery from the controller by inserting the plastic spudger into the small gap on the bottom right of the battery.
  • Use the spudger as a lever to pry up and remove the battery from the compartment.

Remove the battery from the controller by inserting the plastic spudger into the small gap on the bottom right of the battery.

Use the spudger as a lever to pry up and remove the battery from the compartment.

Step 3

              ZL and ZR Buttons
  • Once the battery has been removed, we will remove the 4 screws in the battery compartment and then the 4 screws around the back of the case. These 8 screws use the Y0 bit. Each of these screws are 5.5 mm.
  • The four screws on the outside are extremely deep into the casing, and the holes are pretty small. You will need to use a 4 mm driver bit extension to reach these screws.

Once the battery has been removed, we will remove the 4 screws in the battery compartment and then the 4 screws around the back of the case. These 8 screws use the Y0 bit. Each of these screws are 5.5 mm.

The four screws on the outside are extremely deep into the casing, and the holes are pretty small. You will need to use a 4 mm driver bit extension to reach these screws.

Step 4

  • Once all of the screws are removed, simply use one hand to hold the front panel in place and lift up on the back panel to remove it. Place the back panel so the insides are facing up towards you.

Once all of the screws are removed, simply use one hand to hold the front panel in place and lift up on the back panel to remove it. Place the back panel so the insides are facing up towards you.

Step 5

  • Locate the two triggers (ZL and ZR) and pop them up and out by pressing on them from the outside.

Locate the two triggers (ZL and ZR) and pop them up and out by pressing on them from the outside.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Jesse Burton

Member since: 09/17/2015

577 Reputation

                                      3 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       IUPUI, Team 2-2, Harley Fall 2015                        

                                                  Member of IUPUI, Team 2-2, Harley Fall 2015 



                    IUPUI-HARLEY-F15S2G2                     


                                            4 Members                     


                                            10 Guides authored