Difficulty
Moderate
Steps
6
Time Required
5 - 10 minutes
Sections
4
- Batteries
- 2 steps
- Front Panel
- 2 steps
- Buttons
- 1 step
- Joystick
- 1 step
Flags
1
Featured Student Guide
This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.
BackGameCube WaveBird
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Batteries
- Pull down on the battery cover release lever and pull back to remove the cover.
Pull down on the battery cover release lever and pull back to remove the cover.
1024
Step 2
- Remove both batteries from the device.
Remove both batteries from the device.
Step 3
Front Panel
- Remove the eight 9 mm screws from the back panel using the Tri-point Y1 screwdriver.
- During reassembly, firmly hold the panels of the controller together while replacing the screws so the panels do not separate.
Remove the eight 9 mm screws from the back panel using the Tri-point Y1 screwdriver.
During reassembly, firmly hold the panels of the controller together while replacing the screws so the panels do not separate.
Step 4
- Carefully turn over the controller and place it on a flat surface.
- Slowly separate the top panel from the bottom panel.
- The buttons are loose and may fall off the motherboard.
- Once separated, set aside the top panel.
- During reassembly, make sure the front panel lines up with the buttons so they slide back into place.
Carefully turn over the controller and place it on a flat surface.
Slowly separate the top panel from the bottom panel.
The buttons are loose and may fall off the motherboard.
Once separated, set aside the top panel.
During reassembly, make sure the front panel lines up with the buttons so they slide back into place.
Step 5
Buttons
- Use tweezers to remove the buttons.
- It may be easier to remove the A button off of the pad by lifting it with your fingers.
- During reassembly, make sure all buttons are in their respective sockets so they match up with the front panel.
Use tweezers to remove the buttons.
It may be easier to remove the A button off of the pad by lifting it with your fingers.
During reassembly, make sure all buttons are in their respective sockets so they match up with the front panel.
Step 6
Joystick
- Grab the base of the grey joystick cover with one hand and firmly hold down the rest of the controller with the other hand.
- Pull off the grey joystick cover.
- During reassembly, make sure the slots inside the joystick cover line up with the motherboard so it can fit back together.
Grab the base of the grey joystick cover with one hand and firmly hold down the rest of the controller with the other hand.
Pull off the grey joystick cover.
During reassembly, make sure the slots inside the joystick cover line up with the motherboard so it can fit back together.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
6 other people completed this guide.
Author
with 5 other contributors
Garrett Leung
Member since: 04/16/2013
916 Reputation
8 Guides authored
Badges:
15
+12 more badges
Team
Cal Poly, Team 10-40, Amido Spring 2013
Member of Cal Poly, Team 10-40, Amido Spring 2013
CPSU-AMIDO-S13S10G40
4 Members
37 Guides authored
