Difficulty

Moderate

Steps

8

Time Required

                          20 minutes

Sections

3

  • Back Panel
  • 2 steps
  • Circuit Board
  • 5 steps
  • Start Button
  • 1 step

Flags

0

  • BackNintendo NES Advantage

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

The Start Button is an input sensory button used for starting and pausing the game.

What you need

Step 1

              Back Panel
  • Remove the four sticky pads from the bottom of the device.
  • If the pads are stuck, use a spudger to remove them.

Remove the four sticky pads from the bottom of the device.

If the pads are stuck, use a spudger to remove them.

1024

Step 2

  • Remove the six 8 mm screws from the bottom of the device with a Phillips #0 screwdriver.
  • Use your hands to pull the back panel away from the controller.

Remove the six 8 mm screws from the bottom of the device with a Phillips #0 screwdriver.

Use your hands to pull the back panel away from the controller.

Step 3

              Circuit Board
  • Remove the three 14 mm screws from the gray cross with a Phillips #0 screwdriver.
  • Lift the gray component away from the device.

Remove the three 14 mm screws from the gray cross with a Phillips #0 screwdriver.

Lift the gray component away from the device.

Step 4

  • Lift up the black wire and move it to the side.

Lift up the black wire and move it to the side.

Step 5

  • Remove the two silver knobs on the front of the device.
  • Unscrew the two silver nuts using a flathead screwdriver.
  • Remove each silver nut and silver washer using a pair of tweezers.

Remove the two silver knobs on the front of the device.

Unscrew the two silver nuts using a flathead screwdriver.

Remove each silver nut and silver washer using a pair of tweezers.

Step 6

  • Remove the remaining three 8 mm screws on the circuit board with a Phillips #0 screwdriver.
  • Remove the silver bracket from the top of the circuit board.

Remove the remaining three 8 mm screws on the circuit board with a Phillips #0 screwdriver.

Remove the silver bracket from the top of the circuit board.

Step 7

  • Remove the circuit board from the controller.

Remove the circuit board from the controller.

Step 8

              Start Button
  • Remove Start Button.

Remove Start Button.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Sylvia Pena

Member since: 09/06/2022

79 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       University of Colorado Denver, Team 1-2, Campeau Fall 2022                        

                                                  Member of University of Colorado Denver, Team 1-2, Campeau Fall 2022 



                    UCDENVER-CAMPEAU-F22S1G2                     


                                            5 Members                     


                                            7 Guides authored