Difficulty

Easy

Steps

7

Time Required

                          5 - 6 minutes

Sections

4

  • Back Panel
  • 2 steps
  • Z Button
  • 1 step
  • Circuit Board
  • 2 steps
  • Directional Pad
  • 2 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackGameCube Controller

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Place the controller (buttons down) on a solid surface.
  • Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.

Place the controller (buttons down) on a solid surface.

Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.

1024

Step 2

  • Gently lift the back panel up, separating it from the front panel.
  • Some of the buttons may fall out if they are knocked around.

Gently lift the back panel up, separating it from the front panel.

Some of the buttons may fall out if they are knocked around.

Step 3

              Z Button
  • Grab the Z-button by the peg with tweezers and lift it out of the controller.
  • During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.

Grab the Z-button by the peg with tweezers and lift it out of the controller.

During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.

Step 4

              Circuit Board
  • Carefully unhook the cable that is looped around the peg.

Carefully unhook the cable that is looped around the peg.

Step 5

  • Lift the circuit board out of the controller.
  • Do not grab the rumble motor to lift the circuit board as shown in the picture. It will in many cases just remove the rumble motor. Instead, grab the edges of the board.

Lift the circuit board out of the controller.

Do not grab the rumble motor to lift the circuit board as shown in the picture. It will in many cases just remove the rumble motor. Instead, grab the edges of the board.

Step 6

              Directional Pad
  • Remove the rubber backing with tweezers.

Remove the rubber backing with tweezers.

Step 7

  • Use tweezers to grab the center peg of the directional pad and lift it out of its socket.

Use tweezers to grab the center peg of the directional pad and lift it out of its socket.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 4 other contributors 


                    Sean Michel

Member since: 01/14/2013

2,061 Reputation

                                      8 Guides authored                  



                       Badges:
                       17







                                                        +14 more badges

Team

                       Cal Poly, Team 19-44, Regan Winter 2013                        

                                                  Member of Cal Poly, Team 19-44, Regan Winter 2013 



                    CPSU-REGAN-W13S19G44                     


                                            4 Members                     


                                            26 Guides authored