Featured
Featured Guide
Difficulty
Easy
Steps
7
Time Required
5 - 6 minutes
Sections
4
- Back Panel
- 2 steps
- Z Button
- 1 step
- Circuit Board
- 2 steps
- Buttons
- 2 steps
Flags
2
Featured Student Guide
This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.
Featured Guide
This guide has been found to be exceptionally cool by the iFixit staff.
BackGameCube Controller
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Place the controller (buttons down) on a solid surface.
- Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.
Place the controller (buttons down) on a solid surface.
Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.
1024
Step 2
- Gently lift the back panel up, separating it from the front panel.
- Some of the buttons may fall out if they are knocked around.
Gently lift the back panel up, separating it from the front panel.
Some of the buttons may fall out if they are knocked around.
Step 3
Z Button
- Grab the Z-button by the peg with tweezers and lift it out of the controller.
- During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.
Grab the Z-button by the peg with tweezers and lift it out of the controller.
During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.
Step 4
Circuit Board
- Carefully unhook the cable that is looped around the peg.
Carefully unhook the cable that is looped around the peg.
Step 5
- Lift the circuit board out of the controller.
- Do not grab the rumble motor to lift the circuit board as shown in the picture. It will in many cases just remove the rumble motor. Instead, grab the edges of the board.
Lift the circuit board out of the controller.
Do not grab the rumble motor to lift the circuit board as shown in the picture. It will in many cases just remove the rumble motor. Instead, grab the edges of the board.
Step 6
Buttons
- Remove the rubber backing that covers the buttons.
Remove the rubber backing that covers the buttons.
Step 7
- Use tweezers to lift buttons out of their sockets.
- When putting the buttons back, make sure the slots properly fit back together.
Use tweezers to lift buttons out of their sockets.
When putting the buttons back, make sure the slots properly fit back together.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
15 other people completed this guide.
Author
with 7 other contributors
Sean Michel
Member since: 01/14/2013
2,061 Reputation
8 Guides authored
Badges:
17
+14 more badges
Team
Cal Poly, Team 19-44, Regan Winter 2013
Member of Cal Poly, Team 19-44, Regan Winter 2013
CPSU-REGAN-W13S19G44
4 Members
26 Guides authored
tp4yourbunghole - Mar 30, 2016
Reply
Is there a way I can buy the buttons separably? I lost a the X button and it’s gone missing and i wanna buy one :(
dariuscorrfz - Aug 12, 2018
Reply
u can either get a 2 dollar full button set on ebay by searching ngc buttons or u can buy from battle beaver customs for 1 dollar
Steven Enns - Aug 15, 2018
Reply
How do you put the back back on?