Difficulty

Easy

Steps

14

Time Required

                          15 minutes

Sections

2

  • Top Cover
  • 5 steps
  • Metal Plate
  • 9 steps

Flags

0

  • BackNintendo 64

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Top Cover
  • Remove the expansion pack cover by pushing in the tab and pulling out.

Remove the expansion pack cover by pushing in the tab and pulling out.

1024

Step 2

  • If your system uses a jumper pack, the same procedure applies to remove it.
  • A small spoon can be used in place of a spudger.
  • Lever the expansion pack out using a metal spudger.

If your system uses a jumper pack, the same procedure applies to remove it.

A small spoon can be used in place of a spudger.

Lever the expansion pack out using a metal spudger.

Step 3

  • Remove the six screws on the bottom side indicated in the example with a gamebit head or screwdriver.

Remove the six screws on the bottom side indicated in the example with a gamebit head or screwdriver.

Step 4

  • Remove the two front feet of the N64.

Remove the two front feet of the N64.

Step 5

  • Rotate to top side up and lift off top cover.

Rotate to top side up and lift off top cover.

Step 6

              Metal Plate
  • Remove the fourteen screws indicated in the example using the larger Phillips screwdriver.

Remove the fourteen screws indicated in the example using the larger Phillips screwdriver.

Step 7

  • Remove the metal plate indicated in the example by sliding it back and then lifting it up.

Remove the metal plate indicated in the example by sliding it back and then lifting it up.

Step 8

  • Remove the two screws indicated in the example using the smaller Phillips screwdriver.

Remove the two screws indicated in the example using the smaller Phillips screwdriver.

Step 9

  • Remove the screw to the right of the LED light using the larger Phillips screwdriver.

Remove the screw to the right of the LED light using the larger Phillips screwdriver.

Step 10

  • Remove the small metal bracket from the back of the expansion pack slot.

Remove the small metal bracket from the back of the expansion pack slot.

Step 11

  • Remove the small metal bracket from the front of the expansion pack slot with the metal spudger.

Remove the small metal bracket from the front of the expansion pack slot with the metal spudger.

Step 12

  • Remove the small metal bracket behind the expansion slot using the spudger.

Remove the small metal bracket behind the expansion slot using the spudger.

Step 13

  • Remove the seven screws indicated in the example using the larger Phillips screwdriver.

Remove the seven screws indicated in the example using the larger Phillips screwdriver.

Step 14

  • Lift off and remove the metal plate as indicated in the example.

Lift off and remove the metal plate as indicated in the example.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 8 other contributors 


                    LisaF818

Member since: 11/29/2009

140 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 5-4, Regan Fall 2009                        

                                                  Member of Cal Poly, Team 5-4, Regan Fall 2009 



                    CPSU-REGAN-F09S5G4                     


                                            7 Members                     


                                            7 Guides authored