Difficulty

Moderate

Steps

7

Time Required

                          20 - 30 minutes

Sections

3

  • Battery
  • 3 steps
  • Rear Panel
  • 3 steps
  • Trigger Button
  • 1 step

Flags

0

  • BackNintendo 2DS

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove the two Phillips captive screws securing the upper rear panel.
  • The captive screws will not completely detach from the back panel.

Remove the two Phillips captive screws securing the upper rear panel.

The captive screws will not completely detach from the back panel.

1024

Step 2

  • Hinge the upper rear panel upwards and outwards to remove it.

Hinge the upper rear panel upwards and outwards to remove it.

Step 3

  • Remove the battery from its housing by lifting it up from the side closest to the outside edge.

Remove the battery from its housing by lifting it up from the side closest to the outside edge.

Step 4

              Rear Panel
  • Remove the ten Phillips screws attaching the rear panel.

Remove the ten Phillips screws attaching the rear panel.

Step 5

  • The rear panel is attached to the motherboard by a ribbon cable, so be careful not to lift the rear panel too far from the device.
  • Carefully pull the rear panel straight up from the device.

The rear panel is attached to the motherboard by a ribbon cable, so be careful not to lift the rear panel too far from the device.

Carefully pull the rear panel straight up from the device.

Step 6

  • Carefully flip the back panel over to locate the attached ribbon cable.
  • Remove the two Phillips screws attaching the ribbon cable to the rear panel.
  • Take the opportunity to remove the Left and Right triggers, they have hinges that may break and springs that may jump away.

Carefully flip the back panel over to locate the attached ribbon cable.

Remove the two Phillips screws attaching the ribbon cable to the rear panel.

Take the opportunity to remove the Left and Right triggers, they have hinges that may break and springs that may jump away.

Step 7

              Remove trigger button
  • The trigger buttons have small springs attached to them, so be careful when removing the buttons from the device.
  • Pull the trigger button away from the device to remove it.

The trigger buttons have small springs attached to them, so be careful when removing the buttons from the device.

Pull the trigger button away from the device to remove it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      20 other people completed this guide.

Author

                                      with 5 other contributors 


                    Fina Beauchamp

Member since: 01/12/2015

2,816 Reputation

                                      6 Guides authored                  



                       Badges:
                       19







                                                        +16 more badges

Team

                       Cal Poly, Team 70-1, Forte Winter 2015                        

                                                  Member of Cal Poly, Team 70-1, Forte Winter 2015 



                    CPSU-FORTE-W15S70G1                     


                                            4 Members                     


                                            31 Guides authored

Minecrafter Pig - Apr 22, 2019

Reply

Nice job! My right button was jammed for at least two years. Now I can finally demolish my friends in Mariokart.

Zom baygal - Dec 28, 2019

Reply

Can’t seem to get the second set of screws to budge at all.

Karim Eltaib - Nov 30, 2022

Reply

now what????