Ninja Ultima Bl810 Power Plug Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          20 - 35 minutes            

Sections

1

• Power Plug
• 8 steps

Flags

0

• BackNinja Ultima BL810

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Power Plug               

• Unscrew the Phillips #0 11mm screws.
• Unscrew the Torx Security #10 11mm screw.

Unscrew the Phillips #0 11mm screws.

Unscrew the Torx Security #10 11mm screw.

1024

Step 2

• Unscrew the six Phillips #2 11mm screws from the remainder of the bottom plate.
• Pull the bottom covering off of the blender.

Unscrew the six Phillips #2 11mm screws from the remainder of the bottom plate.

Pull the bottom covering off of the blender.

Step 3

• Unscrew the two Phillips #2 9mm screws.
• Remove the plastic block.

Unscrew the two Phillips #2 9mm screws.

Remove the plastic block.

Step 4

• Unscrew the four Phillips #2 11mm screws.
• Remove the plastic covers.
• Removing the top cover and then rotating the bottom cover into the same orientation works best.

Unscrew the four Phillips #2 11mm screws.

Remove the plastic covers.

Removing the top cover and then rotating the bottom cover into the same orientation works best.

Step 5

• Unscrew the three Phillips #2 9mm screws.
• This metal plate doesn’t need to be completely removed, just adjusted to the side to continue working.

Unscrew the three Phillips #2 9mm screws.

This metal plate doesn’t need to be completely removed, just adjusted to the side to continue working.

Step 6

• Unscrew the four Phillips #2 11mm screws.
• Pull the power cord through as shown to create slack.
• Remove plastic casing by lifting upwards.

Pull the power cord through as shown to create slack.

Remove plastic casing by lifting upwards.

Step 7

• Follow the power plug cords to find the right plastic caps.
• Squeeze the caps with pliers to loosen the grip.
• Pull the plastic caps off the twisted wires.

Follow the power plug cords to find the right plastic caps.

Squeeze the caps with pliers to loosen the grip.

Pull the plastic caps off the twisted wires.

Step 8

• Untwist the two wires from each other and pull the zip tie off.

Untwist the two wires from each other and pull the zip tie off.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 5 other contributors 

                    Ryan James Gilroy                     

Member since: 09/27/2017

364 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Cal Poly, Team S9-G4, Banghart Fall 2017                        

                                                  Member of Cal Poly, Team S9-G4, Banghart Fall 2017 



                    CPSU-BANGHART-F17S9G4                     


                                            4 Members                     


                                            5 Guides authored