Difficulty
Moderate
Steps
4
Time Required
25 - 30 minutes
Sections
1
- Handle
- 4 steps
Flags
0
BackNinja Ultima BL810
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Handle
- Remove five Phillips #2 9mm screws on the bottom of the blender.
Remove five Phillips #2 9mm screws on the bottom of the blender.
1024
Step 2
- Use a metal spudger to pop out the upper layer of the handle.
- Pull the upper plastic layer off the handle.
Use a metal spudger to pop out the upper layer of the handle.
Pull the upper plastic layer off the handle.
Step 3
- Unhook the latches from each side of the top portion of the handle with the metal spudger.
Unhook the latches from each side of the top portion of the handle with the metal spudger.
Step 4
- Pull the black handle off of the pitcher.
- Don’t pull to hard or you may break the handle off of the base.
- Once it disconnected, pull base and handle down in order to remove it from the pitcher.
Pull the black handle off of the pitcher.
Don’t pull to hard or you may break the handle off of the base.
Once it disconnected, pull base and handle down in order to remove it from the pitcher.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Donald Syracuse
Member since: 09/27/2017
213 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team S9-G4, Banghart Fall 2017
Member of Cal Poly, Team S9-G4, Banghart Fall 2017
CPSU-BANGHART-F17S9G4
4 Members
5 Guides authored
sherahisrael12 - Apr 11, 2019
Reply
Hi there,
Was there a spring when you did this? I took my apart and a spring popped out but I don’t know where it goes? I contacts Ninja and they don’t know exactly where it goes. Can you provide me with some assistance?