Difficulty
Easy
Steps
6
Time Required
5 - 10 minutes
Sections
2
- Blender Base Cover
- 3 steps
- Fan
- 3 steps
Flags
1
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
BackNinja Professional NJ600
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Blender Base Cover
- Remove the five screws (13mm long, 6mm head diameter) using a Phillips #2 screwdriver.
Remove the five screws (13mm long, 6mm head diameter) using a Phillips #2 screwdriver.
1024
Step 2
- Without removing any screws, you can pull the 2nd layer free from the base. Do this now and set it down gently next to the base.
- The power cord runs through a hole in the side of this layer. Squeeze the cord and pull it through the hole to separate the layer from the cord.
Without removing any screws, you can pull the 2nd layer free from the base. Do this now and set it down gently next to the base.
The power cord runs through a hole in the side of this layer. Squeeze the cord and pull it through the hole to separate the layer from the cord.
Step 3
- Using the Phillips #2 screwdriver, remove these six screws (13mm long, 6mm head diameter). Then carefully remove this layer, and rest it next to the blender base.
- Be careful not to damage the two wires that are keeping this third layer attached to the base.
Using the Phillips #2 screwdriver, remove these six screws (13mm long, 6mm head diameter). Then carefully remove this layer, and rest it next to the blender base.
Be careful not to damage the two wires that are keeping this third layer attached to the base.
Step 4
Fan
- Hold the fan steady and use a wrench or pliers to remove the nut in the image.
- The fan is sharp. Use caution when handling with bare hands.
- A towel or gloves may be useful when holding the fan for this step.
Hold the fan steady and use a wrench or pliers to remove the nut in the image.
The fan is sharp. Use caution when handling with bare hands.
A towel or gloves may be useful when holding the fan for this step.
Step 5
- Hold the fan and use the flathead 4.0 screwdriver to loosen the washer.
- The fan is sharp, use caution when handling with bare hands.
- You may use a towel or gloves to avoid handling the fan with your bare hands.
Hold the fan and use the flathead 4.0 screwdriver to loosen the washer.
The fan is sharp, use caution when handling with bare hands.
You may use a towel or gloves to avoid handling the fan with your bare hands.
Step 6
- Slide the washer and fan off of the screw.
Slide the washer and fan off of the screw.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Ryan Heller
Member since: 04/01/2015
107 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
Cal Poly, Team 24-2, Lancaster Spring 2015
Member of Cal Poly, Team 24-2, Lancaster Spring 2015
CPSU-LANCASTER-S15S24G2
4 Members
6 Guides authored