Difficulty
Moderate
Steps
6
Time Required
20 minutes
Sections
2
- Circuit Base
- 4 steps
- Power Cord
- 2 steps
Flags
0
BackNinja Mega Kitchen System BL770
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Circuit Base
- Remove the five screws (13mm long, 6mm head) attaching the Base Cover using a Phillips screwdriver (Ph2).
- Remove the two screws (13 mm long, 6mm head) attaching the Base Cover using a T10 screwdriver.
Remove the five screws (13mm long, 6mm head) attaching the Base Cover using a Phillips screwdriver (Ph2).
Remove the two screws (13 mm long, 6mm head) attaching the Base Cover using a T10 screwdriver.
1024
Step 2
- Carefully remove the second layer from the base. You will not need a screwdriver for this step.
Carefully remove the second layer from the base. You will not need a screwdriver for this step.
Step 3
- Remove the 2 screws (13mm, 6mm head) connected to the plastic piece holding down the power cord.
- Then remove the additional 4 screws (13mm, 6mm head) and 2 screws (11mm, 5mm head) securing the base.
- Carefully lift the base up from the rest of the blender.
Remove the 2 screws (13mm, 6mm head) connected to the plastic piece holding down the power cord.
Then remove the additional 4 screws (13mm, 6mm head) and 2 screws (11mm, 5mm head) securing the base.
Carefully lift the base up from the rest of the blender.
Step 4
- Remove 4 screws (11mm, 4mm head) connecting the circuit board to the base.
Remove 4 screws (11mm, 4mm head) connecting the circuit board to the base.
Step 5
Power Cord
- Check that the two red wires shown in the photos are properly soldered to the circuit board.
- If they seem damaged, resolder the wires to the board.
- If this doesn’t solve the issue, proceed to step 6.
Check that the two red wires shown in the photos are properly soldered to the circuit board.
If they seem damaged, resolder the wires to the board.
If this doesn’t solve the issue, proceed to step 6.
Step 6
- If the 2 wires in the previous step are connected, it’s time to check the 2nd area.
- Remove the plastic covers and check that the wires are soldered correctly.
If the 2 wires in the previous step are connected, it’s time to check the 2nd area.
Remove the plastic covers and check that the wires are soldered correctly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Tommee Walker
Member since: 08/22/2017
742 Reputation
6 Guides authored
Badges:
10
+7 more badges
Team
Arkansas State University, Team S1-G4, Chamberlain Fall 2017
Member of Arkansas State University, Team S1-G4, Chamberlain Fall 2017
ARSU-CHAMBERLAIN-F17S1G4
2 Members
6 Guides authored