Difficulty
Moderate
Steps
2
Time Required
20 minutes
Sections
1
- LED Light
- 2 steps
Flags
0
BackNinja Mega Kitchen System BL770
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
LED Light
- On the circuit board, locate the LED light you wish to replace.
- On the bottom of the board, each LED is designated with a small triangle with a line at one tip and a label of LED1, LED2, etc.
On the circuit board, locate the LED light you wish to replace.
On the bottom of the board, each LED is designated with a small triangle with a line at one tip and a label of LED1, LED2, etc.
1024
Step 2
- Desolder the two LED leads to the specific bulb.
- Remove the LED from the circuit board.
- Properly install the new LED and solder to the board.
Desolder the two LED leads to the specific bulb.
Remove the LED from the circuit board.
Properly install the new LED and solder to the board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Tommee Walker
Member since: 08/22/2017
742 Reputation
6 Guides authored
Badges:
10
+7 more badges
Team
Arkansas State University, Team S1-G4, Chamberlain Fall 2017
Member of Arkansas State University, Team S1-G4, Chamberlain Fall 2017
ARSU-CHAMBERLAIN-F17S1G4
2 Members
6 Guides authored