Ninja Mega Kitchen System Bl770 Cooling Fan Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          20 - 25 minutes            

Sections

2

• Circuit Base
• 4 steps
• Cooling Fan
• 1 step

Flags

0

• BackNinja Mega Kitchen System BL770

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Circuit Base               

• Remove the five screws (13mm long, 6mm head) attaching the Base Cover using a Phillips screwdriver (Ph2).
• Remove the two screws (13 mm long, 6mm head) attaching the Base Cover using a T10 screwdriver.

Remove the five screws (13mm long, 6mm head) attaching the Base Cover using a Phillips screwdriver (Ph2).

Remove the two screws (13 mm long, 6mm head) attaching the Base Cover using a T10 screwdriver.

1024

Step 2

• Carefully remove the second layer from the base. You will not need a screwdriver for this step.

Carefully remove the second layer from the base. You will not need a screwdriver for this step.

Step 3

• Remove the 2 screws (13mm, 6mm head) connected to the plastic piece holding down the power cord.
• Then remove the additional 4 screws (13mm, 6mm head) and 2 screws (11mm, 5mm head) securing the base.
• Carefully lift the base up from the rest of the blender.

Remove the 2 screws (13mm, 6mm head) connected to the plastic piece holding down the power cord.

Then remove the additional 4 screws (13mm, 6mm head) and 2 screws (11mm, 5mm head) securing the base.

Carefully lift the base up from the rest of the blender.

Step 4

• Remove 4 screws (11mm, 4mm head) connecting the circuit board to the base.

Remove 4 screws (11mm, 4mm head) connecting the circuit board to the base.

Step 5

              Cooling Fan               

• Using caution, hold the fan steady and use a wrench or pliers to remove the nut securing the fan.
• Loosen the washer with a flathead screwdriver, then remove the fan and replace with a new one.

Using caution, hold the fan steady and use a wrench or pliers to remove the nut securing the fan.

Loosen the washer with a flathead screwdriver, then remove the fan and replace with a new one.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Tommee Walker                     

Member since: 08/22/2017

742 Reputation

                                      6 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       Arkansas State University, Team S1-G4, Chamberlain Fall 2017                        

                                                  Member of Arkansas State University, Team S1-G4, Chamberlain Fall 2017 



                    ARSU-CHAMBERLAIN-F17S1G4                     


                                            2 Members                     


                                            6 Guides authored