Difficulty
Easy
Steps
3
Time Required
30 minutes
Sections
1
- Power Cable
- 3 steps
Flags
0
BackNinja Coffee Bar Single-Serve System CF111 30
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Cable
- Unscrew the eight 6mm #1 Phillips head screws off the bottom panel.
- Lift lower panel up while passing the power cord through the opening.
Unscrew the eight 6mm #1 Phillips head screws off the bottom panel.
Lift lower panel up while passing the power cord through the opening.
1024
Step 2
- Loosen two 6mm #1 Phillips head and remove clamp holding power cable.
Loosen two 6mm #1 Phillips head and remove clamp holding power cable.
Step 3
- Pull the power cable out exposing the two crimped ends.
- Using a wire stripper/crimping tool, uncrimp wires.
- Wiring connectors are sealed together making them difficult to disconnect. Cutting and rewiring should be considered.
Pull the power cable out exposing the two crimped ends.
Using a wire stripper/crimping tool, uncrimp wires.
Wiring connectors are sealed together making them difficult to disconnect. Cutting and rewiring should be considered.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
CJ Berg
Member since: 11/05/2018
444 Reputation
4 Guides authored
Badges:
5
+2 more badges
Team
UMass Dartmouth, Team S5-G4, Gulbrandsen Fall 2018
Member of UMass Dartmouth, Team S5-G4, Gulbrandsen Fall 2018
UMASSD-GULBRANDSEN-F18S5G4
3 Members
5 Guides authored