Nikon S3700 Lcd Display Screen Replacement Repair Guide

Difficulty

Moderate

Steps

2

Time Required

                          20 minutes            

Sections

1

• LCD Display Screen
• 2 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackNikon Coolpix s3700

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Removing the Screws               

• group screws according to color code.
• Remove exterior screws

group screws according to color code.

Remove exterior screws

1024

Step 2

              Replace LCD               

• Remove Rear casing.
• With a thin blade, gently lift the top tight hand side of the buttons board releasing a peg from a hole on the midframe below. Whilst doing so, gently push on the top left hand side in order to release the buttons board from a clip. At the same time, the bottom left hand corner wil be released from another clip.
• Flip over rear buttons board to expose LCD ZIF clamp.
• Flip open the clamp of the ZIF connector and slide the ribbon cable out. (The connector may have a piece of sticky tape over it. Removing this may well open the connector clamping bar.)
• The ZIF clamp is very fragile so please use caution when releasing the ZIF clamp. It breaks easily.
• Remove the LCD.

Remove Rear casing.

With a thin blade, gently lift the top tight hand side of the buttons board releasing a peg from a hole on the midframe below. Whilst doing so, gently push on the top left hand side in order to release the buttons board from a clip. At the same time, the bottom left hand corner wil be released from another clip.

Flip over rear buttons board to expose LCD ZIF clamp.

Flip open the clamp of the ZIF connector and slide the ribbon cable out. (The connector may have a piece of sticky tape over it. Removing this may well open the connector clamping bar.)

The ZIF clamp is very fragile so please use caution when releasing the ZIF clamp. It breaks easily.

Remove the LCD.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Sales Cameraparts4you                     

Member since: 07/01/2016

3,042 Reputation

                                      20 Guides authored                  



                       Badges:
                       17







                                                        +14 more badges