Difficulty
Difficult
Steps
9
Time Required
45 minutes
Sections
1
- Viewfinder
- 9 steps
Flags
2
Needs More Images
A few more images would make this guide’s procedures crystal clear.
Missing Prerequisites
This guide is missing information on how to start the process. Make a prerequisite guide!
BackNikon N80
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Viewfinder
- Make sure the On/Off switch is in the Off position.
Make sure the On/Off switch is in the Off position.
1024
Step 2
- Remove the four 4.8mm screws on the top section of the camera using a PH00 Phillips screwdriver.
- Two are located by the viewfinder and and the other two are on each side of the camera.
Remove the four 4.8mm screws on the top section of the camera using a PH00 Phillips screwdriver.
Two are located by the viewfinder and and the other two are on each side of the camera.
Step 3
- Rotate the camera so the bottom plate is accessible.
- Remove the seven 4.8mm screws on the bottom plate of the camera using a PH00 Phillips screwdriver.
- Separate the bottom plate.
Rotate the camera so the bottom plate is accessible.
Remove the seven 4.8mm screws on the bottom plate of the camera using a PH00 Phillips screwdriver.
Separate the bottom plate.
Step 4
- Remove the five silver 4.8mm screws on the lens mount using a PH00 Phillips screwdriver.
- Extract the lens mount.
Remove the five silver 4.8mm screws on the lens mount using a PH00 Phillips screwdriver.
Extract the lens mount.
Step 5
- Remove the seven 4.8mm screws on front camera plate using a PH00 Phillips screwdriver.
- One is located on the battery chamber side of the camera, two are next to the film door release lever, two are located below the “Nikon” logo, and the last two are located above the “Nikon” logo in the Speedlight compartment.
Remove the seven 4.8mm screws on front camera plate using a PH00 Phillips screwdriver.
One is located on the battery chamber side of the camera, two are next to the film door release lever, two are located below the “Nikon” logo, and the last two are located above the “Nikon” logo in the Speedlight compartment.
Step 6
- Separate the three front camera plates from the camera.
Separate the three front camera plates from the camera.
Step 7
- Gently disconnect the top section of the camera from the body.
- Don’t pull the top section off too hard or the wire and ribbon within the camera may disconnect.
Gently disconnect the top section of the camera from the body.
Don’t pull the top section off too hard or the wire and ribbon within the camera may disconnect.
Step 8
- Remove the two 4.8mm screws next to the viewfinder with a PH00 Phillips screwdriver.
Remove the two 4.8mm screws next to the viewfinder with a PH00 Phillips screwdriver.
Step 9
- Pull out the viewfinder gently.
Pull out the viewfinder gently.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Maegan Viloria
Member since: 09/14/2015
696 Reputation
5 Guides authored
Badges:
8
+5 more badges
Team
CSU Fullerton, Team 1-7, Bruce Fall 2015
Member of CSU Fullerton, Team 1-7, Bruce Fall 2015
CSUF-BRUCE-F15S1G7
3 Members
6 Guides authored
Test Test - Apr 24, 2019
Reply
This is a great guide, thank you!