Difficulty
Easy
Steps
4
Time Required
5 minutes
Sections
1
- Lens Mount (aka Bayonet Mount)
- 4 steps
Flags
Needs More Images
A few more images would make this guide’s procedures crystal clear.
BackNikon N80
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Lens Mount (aka Bayonet Mount)
- Make sure the On/Off switch is in the Off position.
Make sure the On/Off switch is in the Off position.
1024
Step 2
- Place the camera so the lens is facing up.
- If your camera has a lens on, remove it by pushing and holding the lens release button and turning the lens clockwise until it comes off.
Place the camera so the lens is facing up.
If your camera has a lens on, remove it by pushing and holding the lens release button and turning the lens clockwise until it comes off.
Step 3
- Use a PH00 Phillips screwdriver to remove the five 4.8mm screws on the silver lens mount.
Use a PH00 Phillips screwdriver to remove the five 4.8mm screws on the silver lens mount.
Step 4
- Remove the old lens mount and place the new one on.
Remove the old lens mount and place the new one on.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Maegan Viloria
Member since: 09/14/2015
696 Reputation
5 Guides authored
Badges:
8
+5 more badges
Team
CSU Fullerton, Team 1-7, Bruce Fall 2015
Member of CSU Fullerton, Team 1-7, Bruce Fall 2015
CSUF-BRUCE-F15S1G7
3 Members
6 Guides authored