Difficulty
Easy
Steps
4
Time Required
15 minutes
Sections
1
- Gear Belt for Film Winding
- 4 steps
Flags
Missing Prerequisites
This guide is missing information on how to start the process. Make a prerequisite guide!
BackNikon N80
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Gear Belt for Film Winding
- Make sure the On/Off switch is in the Off position.
Make sure the On/Off switch is in the Off position.
1024
Step 2
- Rotate the camera so the bottom plate is accessible.
- Remove the seven 4.8mm screws on the bottom plate of the camera using a PH00 Phillips screwdriver.
- Remove the bottom plate.
Rotate the camera so the bottom plate is accessible.
Remove the seven 4.8mm screws on the bottom plate of the camera using a PH00 Phillips screwdriver.
Remove the bottom plate.
Step 3
- Remove the eight 4.8mm screws holding on the metal plate.
- Remove the metal plate.
Remove the eight 4.8mm screws holding on the metal plate.
Remove the metal plate.
Step 4
- Gently remove the black, rubber gear belt.
- Discard the old belt responsibly.
- Place new belt on.
Gently remove the black, rubber gear belt.
Discard the old belt responsibly.
Place new belt on.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 3 other contributors
Maegan Viloria
Member since: 09/14/2015
696 Reputation
5 Guides authored
Badges:
8
+5 more badges
Team
CSU Fullerton, Team 1-7, Bruce Fall 2015
Member of CSU Fullerton, Team 1-7, Bruce Fall 2015
CSUF-BRUCE-F15S1G7
3 Members
6 Guides authored
