Difficulty
Moderate
Steps
6
Time Required
30 - 40 minutes
Sections
1
- Rear Display Buttons
- 6 steps
Flags
0
BackNikon D90
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Removing Casing Screws
- Locate the screws on both sides of the camera.
- Remove the four 6.3 mm Phillips screws using a PH00 screwdriver.
- Be careful not to strip the screws.
Locate the screws on both sides of the camera.
Remove the four 6.3 mm Phillips screws using a PH00 screwdriver.
Be careful not to strip the screws.
1024
Step 2
Removing the Rear Casing
- Use a plastic opening tool to separate the rear case from the camera.
Use a plastic opening tool to separate the rear case from the camera.
Step 3
Disconnecting the Ribbon Cables
- After, remove the two orange ribbon connectors attached to the interior of the camera with tweezers.
- Make sure to remove the ribbon cables carefully from the connectors to avoid damaging the camera.
After, remove the two orange ribbon connectors attached to the interior of the camera with tweezers.
Make sure to remove the ribbon cables carefully from the connectors to avoid damaging the camera.
Step 4
Removing the Screws from the Rear Casing
- Remove the screws from the back assembly with a Phillips (PH00) head screwdriver.
- Remove the ten 5.3 mm Phillips screws.
- Remove the three 4.3 mm Phillips screws.
Remove the screws from the back assembly with a Phillips (PH00) head screwdriver.
Remove the ten 5.3 mm Phillips screws.
Remove the three 4.3 mm Phillips screws.
Step 5
Removing the LCD and other components
- Use a plastic opening tool to separate the LCD and metal plates from the casing.
Use a plastic opening tool to separate the LCD and metal plates from the casing.
Step 6
Removing the Display Buttons
- Use a plastic opening tool to separate the buttons from the casing.
- Remove the 4.3 mm Phillips screw from the knob using a PH00 screwdriver.
Use a plastic opening tool to separate the buttons from the casing.
Remove the 4.3 mm Phillips screw from the knob using a PH00 screwdriver.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
jonothon cawley
Member since: 10/20/2014
354 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
UMass Dartmouth, Team 1-7, Duarte Fall 2014
Member of UMass Dartmouth, Team 1-7, Duarte Fall 2014
UMASSD-DUARTE-F14S1G7
3 Members
6 Guides authored