Difficulty
Moderate
Steps
6
Time Required
20 minutes
Sections
1
- Screen
- 6 steps
Flags
0
BackNikon D5200
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Screen
- Fully open the LCD panel so that its screws are easily accessible.
- Remove the two 2.5 mm screws from the outside edge of the screen casing, and the two 3.5 mm screws from the inside edge.
Fully open the LCD panel so that its screws are easily accessible.
Remove the two 2.5 mm screws from the outside edge of the screen casing, and the two 3.5 mm screws from the inside edge.
1024
Step 2
- Pry open the plastic casing using the opening tool or by hand.
Pry open the plastic casing using the opening tool or by hand.
Step 3
- Use the plastic opening tool to pop up the latch holding the ribbon cable on the right side of the circuit board, and remove it.
- Use the plastic opening tool to pry the ribbon cable on the left side of the circuit board up and off of its socket.
Use the plastic opening tool to pop up the latch holding the ribbon cable on the right side of the circuit board, and remove it.
Use the plastic opening tool to pry the ribbon cable on the left side of the circuit board up and off of its socket.
Step 4
- Using tweezers, unplug the smaller cable.
Using tweezers, unplug the smaller cable.
Step 5
- Desolder the three small wires on the left side of the circuit board.
- Soldering irons become very hot when in use. Take all necessary precautions to avoid injury.
Desolder the three small wires on the left side of the circuit board.
Soldering irons become very hot when in use. Take all necessary precautions to avoid injury.
Step 6
- Using a spudger, remove the display from its casing.
Using a spudger, remove the display from its casing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
13 other people completed this guide.
Author
with 4 other contributors
Alexander Corn
Member since: 08/26/2015
1,211 Reputation
5 Guides authored
Badges:
14
+11 more badges
Team
USF Tampa, Team 3-1, Eyestone Fall 2015
Member of USF Tampa, Team 3-1, Eyestone Fall 2015
USFT-EYESTONE-F15S3G1
4 Members
5 Guides authored
isaac - Nov 24, 2016
Reply
Do I need to de-solder if I’m just replacing the window glass?
Joseph Morris - Apr 17, 2017
Reply
To isaac: no. The exterior glass is separate from the LCD.
g_atki - Jun 28, 2017
Reply
Do you recommend the replacent for LCD sold on Ebay?
Heather Miller - Aug 8, 2017
Reply
Where did you find the replacement screen? The one I ordered that says it’s for the d5200 is not the same as the one in it or in your pictures.
Amanda Bruyninckx - Oct 23, 2017
Reply
How do you disconnect the multi-plug that is shown connected in image 4 and disconnected in image five? Does it unclip or slide out?