Difficulty
Moderate
Steps
10
Time Required
10 minutes
Sections
2
- Nikon D500 Memory Card Cover Disassembly
- 4 steps
- Nikon D500 Back Panel Removal
- 6 steps
Flags
1
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackNikon D500
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove 2 exposed screws
- Remove the 2 screws beside the memory slots, then close the cover.
- Note: make sure to remove the memory cards first!
Remove the 2 screws beside the memory slots, then close the cover.
Note: make sure to remove the memory cards first!
1024
Step 2
Remove 2 screws under grip
- Remove the 2 screws under the rubber grip part by peeling back the rubber grip
- Try not to damage the double sided adhesive under the rubber.
Remove the 2 screws under the rubber grip part by peeling back the rubber grip
Try not to damage the double sided adhesive under the rubber.
Step 3
Remove 2 screws under rear grip
- Remove the 2 screws under the rubber pad marked in red.
- Try not to damage the double-sided adhesive under the rubber.
- Note: There is a 3rd screw under the flap, which holds the back to the top (marked in yellow). If needing to remove the back panel not just the memory cover flap, it can be removed at this time as well.
Remove the 2 screws under the rubber pad marked in red.
Try not to damage the double-sided adhesive under the rubber.
Note: There is a 3rd screw under the flap, which holds the back to the top (marked in yellow). If needing to remove the back panel not just the memory cover flap, it can be removed at this time as well.
Step 4
Lift out panel
- Lift out the assembly panel, it should come free without much force.
- May open the panel to release it.
Lift out the assembly panel, it should come free without much force.
May open the panel to release it.
Step 5
Remove top screw
- Remove the screw above the viewfinder
Remove the screw above the viewfinder
Step 6
Remove the bottom panel plate
- Remove the 4 screws holding the plate to the bottom.
- Remove the bottom plate
Remove the 4 screws holding the plate to the bottom.
Remove the bottom plate
Step 7
Remove screws from the bottom
- Remove the 4 screws (1 was under the plate)
Remove the 4 screws (1 was under the plate)
Step 8
Remove Screw under grip
- Remove the screw under the grip
Remove the screw under the grip
Step 9
Remove Screw on Left
- Remove the exposed screw on the Left side
Remove the exposed screw on the Left side
Step 10
Carefully remove the back assembly
- Carefully pull the back plate off the camera
- There are 2 ribbon cables that need to be disconnected from the main board to free the rear panel from the camera.
Carefully pull the back plate off the camera
There are 2 ribbon cables that need to be disconnected from the main board to free the rear panel from the camera.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Wolphin
Member since: 11/11/2019
1,420 Reputation
8 Guides authored
Badges:
15
+12 more badges