Difficulty
Moderate
Steps
9
Time Required
30 minutes
Sections
2
- Back Cover
- 4 steps
- Viewfinder
- 5 steps
Flags
0
BackNikon D40
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Remove the two visible 6.0 mm Philips #0 screws on the left and right sides of the viewfinder. These screws are highlighted in red.
Remove the two visible 6.0 mm Philips #0 screws on the left and right sides of the viewfinder. These screws are highlighted in red.
1024
Step 2
- Remove the four 6.0 mm Philips #0 screws on the left and right sides of the camera.
Remove the four 6.0 mm Philips #0 screws on the left and right sides of the camera.
Step 3
- Remove the four highlighted 3.0 mm Philips #0 screws on the bottom of the camera.
Remove the four highlighted 3.0 mm Philips #0 screws on the bottom of the camera.
Step 4
- While pulling the bottom down, remove the back of the camera.
- Be careful not to pull too hard on the back as it is connected via a ribbon cable. Be sure to disconnect this cable on the main board.
- To disconnect the ribbon cable pull the small black tab upward and pull gently on the cable.
While pulling the bottom down, remove the back of the camera.
Be careful not to pull too hard on the back as it is connected via a ribbon cable. Be sure to disconnect this cable on the main board.
To disconnect the ribbon cable pull the small black tab upward and pull gently on the cable.
Step 5
Viewfinder
- You will be able to see the ribbon cables coming out from the back panel, disconnect the cables.
- Be careful not to pull too hard on the ribbon cables.
You will be able to see the ribbon cables coming out from the back panel, disconnect the cables.
Be careful not to pull too hard on the ribbon cables.
Step 6
- Slowly push the upper body up until you see the frame of the viewfinder
- Be careful while pulling the top camera body.
Slowly push the upper body up until you see the frame of the viewfinder
Be careful while pulling the top camera body.
Step 7
- Use a spudger to keep the upper body separate from the printed circuit board.
- Wiggle the plastic eyepiece out of the frame. This may require some force.
Use a spudger to keep the upper body separate from the printed circuit board.
Wiggle the plastic eyepiece out of the frame. This may require some force.
Step 8
- Remove the viewfinder with the plastic opening tool.
- Do not push too hard while using the opening tool.
Remove the viewfinder with the plastic opening tool.
Do not push too hard while using the opening tool.
Step 9
- The viewfinder has been removed!
The viewfinder has been removed!
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 1 other contributor
Amy Chen
Member since: 01/23/2014
183 Reputation
1 Guide authored
Badges:
6
+3 more badges
Team
Cal Poly, Team 6-19, Maness Winter 2014
Member of Cal Poly, Team 6-19, Maness Winter 2014
CPSU-MANESS-W14S6G19
4 Members
7 Guides authored