Difficulty
Easy
Steps
6
Time Required
10 minutes
Sections
1
- Flash Pin
- 6 steps
Flags
0
BackNikon D40
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Flash Pin
- Turn off the camera and remove the battery.
Turn off the camera and remove the battery.
1024
Step 2
- Pry the flash open using the plastic opening tool.
Pry the flash open using the plastic opening tool.
Step 3
- Remove the two Phillips #0 3.0 mm screws from the front of the flash compartment using the small Phillips Head screwdriver.
Remove the two Phillips #0 3.0 mm screws from the front of the flash compartment using the small Phillips Head screwdriver.
Step 4
- Pry off the back plastic of the flash compartment using the plastic opening tool.
- When it is time to reassemble the flash module, a certain amount of force and precise alignment will be required.
Pry off the back plastic of the flash compartment using the plastic opening tool.
When it is time to reassemble the flash module, a certain amount of force and precise alignment will be required.
Step 5
- On the left of the camera you will see a metal spring.
- Unscrew the Phillips #0 3.0 mm screw holding the spring in place, using the small Phillips Head screwdriver.
On the left of the camera you will see a metal spring.
Unscrew the Phillips #0 3.0 mm screw holding the spring in place, using the small Phillips Head screwdriver.
Step 6
- Remove metal spring and replace with new spring.
Remove metal spring and replace with new spring.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 4 other contributors
Lindsey Chase
Member since: 01/21/2014
227 Reputation
1 Guide authored
Badges:
8
+5 more badges
Team
Cal Poly, Team 6-19, Maness Winter 2014
Member of Cal Poly, Team 6-19, Maness Winter 2014
CPSU-MANESS-W14S6G19
4 Members
7 Guides authored