Difficulty
Moderate
Steps
8
Time Required
10 minutes
Sections
2
- Menu Wheel and OK Button
- 4 steps
- Motherboard
- 4 steps
Flags
Confusing Text
Some of this guide’s text is confusing, duplicated, or off-topic. Clarify it by editing!
Missing Details
Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.
BackNikon Coolpix S9050
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Menu Wheel and OK Button
- Remove the screws. There are two on each side, and four on the bottom. The black screws are 3.2 mm Phillips #000. The silver screws are also 3.2 mm Phillips #000.
Remove the screws. There are two on each side, and four on the bottom. The black screws are 3.2 mm Phillips #000. The silver screws are also 3.2 mm Phillips #000.
1024
Step 2
- Remove the screen housing and trim piece.
Remove the screen housing and trim piece.
Step 3
- Press down and pull the Menu Wheel/OK Button panel towards the screen. This will release the panel from the slots.
Press down and pull the Menu Wheel/OK Button panel towards the screen. This will release the panel from the slots.
Step 4
- Lift up on the black plastic tab(zero insertion force connector-ZIF) and gently pull the panel out to detach the ribbon cable from the camera body.
Lift up on the black plastic tab(zero insertion force connector-ZIF) and gently pull the panel out to detach the ribbon cable from the camera body.
Step 5
Motherboard
- Remove the screws surrounding the screen using the Phillips #000 screwdriver.
- Use the spudger to detach the display ribbon cable.
Remove the screws surrounding the screen using the Phillips #000 screwdriver.
Use the spudger to detach the display ribbon cable.
Step 6
- Remove the silver 3.2 mm Phillips #000 screws surrounding the metal panel.
Remove the silver 3.2 mm Phillips #000 screws surrounding the metal panel.
Step 7
- Remove the silver 3.2 mm Phillips #000 screws from the side panel.
Remove the silver 3.2 mm Phillips #000 screws from the side panel.
Step 8
- After removing metal panel, use the spudger to detach the the 3 ribbon wires attached to the motherboard. Now, remove the silver 3.2 mm Phillips #000 screws holding the motherboard in place. Lastly, lift the board from the top of the camera and pull board upwards, pulling out the AV port with it.
After removing metal panel, use the spudger to detach the the 3 ribbon wires attached to the motherboard. Now, remove the silver 3.2 mm Phillips #000 screws holding the motherboard in place. Lastly, lift the board from the top of the camera and pull board upwards, pulling out the AV port with it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Kyle Gildner
Member since: 11/05/2019
193 Reputation
2 Guides authored
Badges:
2
Team
IUPUI, Team S1-G5, Stella Fall 2019
Member of IUPUI, Team S1-G5, Stella Fall 2019
IUPUI-STELLA-F19S1G5
3 Members
5 Guides authored