Featured
Featured Guide
Difficulty
Moderate
Steps
8
Time Required
20 minutes
Sections
2
- Back Cover
- 5 steps
- Lens
- 3 steps
Flags
Featured Guide
This guide has been found to be exceptionally cool by the iFixit staff.
Better Introduction
Improve this guide by completing or revising its introduction.
BackNikon Coolpix S51c
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Remove all five screws from the bottom of the camera using a Phillips #00 screwdriver.
Remove all five screws from the bottom of the camera using a Phillips #00 screwdriver.
1024
Step 2
- Open the battery door by sliding it in the direction of the arrow to reveal a hidden screw on the opposite side of the orange lever.
- Remove this screw using a Phillips #00 screwdriver.
Open the battery door by sliding it in the direction of the arrow to reveal a hidden screw on the opposite side of the orange lever.
Remove this screw using a Phillips #00 screwdriver.
Step 3
- Rotate the camera to find the side panel with the lanyard attachment.
- Detach the side panel by the lifting bottom corner slightly with the spudger.
Rotate the camera to find the side panel with the lanyard attachment.
Detach the side panel by the lifting bottom corner slightly with the spudger.
Step 4
- Lift the back cover, being careful not to rip the orange cables between the camera and the back cover.
Lift the back cover, being careful not to rip the orange cables between the camera and the back cover.
Step 5
- With the back cover lifted, lift the black flap that connects the ribbon to the motherboard with the spudger and carefully remove the back cover.
With the back cover lifted, lift the black flap that connects the ribbon to the motherboard with the spudger and carefully remove the back cover.
Step 6
Lens
- Remove the five screws on the metal plate.
- One of them is in a hole in the corner of the metal plate.
- Remove the screw at the bottom of the camera.
- Carefully lift the metal plate from the right side to reveal a ribbon connected to the motherboard.
Remove the five screws on the metal plate.
One of them is in a hole in the corner of the metal plate.
Remove the screw at the bottom of the camera.
Carefully lift the metal plate from the right side to reveal a ribbon connected to the motherboard.
Step 7
- Lift the white flap with the spudger to release the ribbon.
- Remove the back metal plate.
Lift the white flap with the spudger to release the ribbon.
Remove the back metal plate.
Step 8
- Lift the two ribbons with the spudger to disconnect the lens and pull it out.
Lift the two ribbons with the spudger to disconnect the lens and pull it out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 8 other contributors
Ryan
Member since: 04/12/2011
146 Reputation
6 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 18-24, Garner Spring 2011
Member of Cal Poly, Team 18-24, Garner Spring 2011
CPSU-GARNER-S11S18G24
4 Members
6 Guides authored