Nikon Coolpix S3100 Camera Holder Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

2

• Nikon Coolpix S3100 disassembly
• 3 steps
• Holder
• 2 steps

Flags

0

• BackNikon Coolpix S3100 Camera

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Nikon Coolpix S3100 disassembly               

• Remove 8-2.46 mm screws from both sides and bottom of camera using a #000 Phillips screwdriver.
• Remove 2 screws from left side. (picture 1)
• Remove 4 screws from bottom. (picture 2)
• Remove 2 screws from right side. (picture 3)

Remove 8-2.46 mm screws from both sides and bottom of camera using a #000 Phillips screwdriver.

Remove 2 screws from left side. (picture 1)

Remove 4 screws from bottom. (picture 2)

Remove 2 screws from right side. (picture 3)

1024

Step 2

• Remove black cover pulling up with left thumb. Hold silver cover with right thumb.
• Remove silver cover lifting up with left thumb. Hold the camera with right thumb.
• Once internal circuit board is exposed, the red and blue wire terminals at top center can provide a nasty shock from the charged flash capacitor (silver can to left of terminals). BE CAREFUL!

Remove black cover pulling up with left thumb. Hold silver cover with right thumb.

Remove silver cover lifting up with left thumb. Hold the camera with right thumb.

Once internal circuit board is exposed, the red and blue wire terminals at top center can provide a nasty shock from the charged flash capacitor (silver can to left of terminals). BE CAREFUL!

Step 3

• Remove 2-2.10mm screws in the front of the camera using a #000 Phillips screwdriver.
• Remove the two screws.
• Gently pull up to detach the frame. (picture 2)

Remove 2-2.10mm screws in the front of the camera using a #000 Phillips screwdriver.

Remove the two screws.

Gently pull up to detach the frame. (picture 2)

Step 4

              Holder               

• Remove 2-2.90mm using a #000 Phillips screwdriver.

Remove 2-2.90mm using a #000 Phillips screwdriver.

Step 5

• Remove by using a pair of tweezers.

Remove by using a pair of tweezers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Jorge                     

Member since: 03/11/2015

1,170 Reputation

                                      7 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges                           

Team

                       Colorado Springs, Team 2-4, Panko Spring 2015                        

                                                  Member of Colorado Springs, Team 2-4, Panko Spring 2015 



                    UCCS-PANKO-S15S2G4                     


                                            2 Members                     


                                            13 Guides authored