Difficulty

Moderate

Steps

10

Time Required

                          10 - 15 minutes

Sections

3

  • Outer Cover
  • 4 steps
  • LCD
  • 3 steps
  • Motherboard
  • 3 steps

Flags

0

  • BackNikon Coolpix S220

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Outer Cover
  • Remove the two 2.8 mm screws on the left side of the camera.

Remove the two 2.8 mm screws on the left side of the camera.

1024

Step 2

  • Remove the four 2.8 mm screws on the right side of the camera.

Remove the four 2.8 mm screws on the right side of the camera.

Step 3

  • Remove the three 4.1 mm screws on the bottom of the camera.

Remove the three 4.1 mm screws on the bottom of the camera.

Step 4

  • Gently lift the rear cover from the camera.

Gently lift the rear cover from the camera.

Step 5

              LCD
  • Gently lift the screen out of its place.
  • You will need to hold the screen slightly above the camera because it will still be attached to the camera by an orange ribbon cable.

Gently lift the screen out of its place.

You will need to hold the screen slightly above the camera because it will still be attached to the camera by an orange ribbon cable.

Step 6

  • Use the tweezers to lift the ZIF connector which is holding the ribbon cables that connect the LCD screen to the motherboard.

Use the tweezers to lift the ZIF connector which is holding the ribbon cables that connect the LCD screen to the motherboard.

Step 7

  • Slowly pull the screen from the camera.

Slowly pull the screen from the camera.

Step 8

              Motherboard
  • Remove the four 3.8 mm screws located near the bottom right and top left of the LCD base plate.

Remove the four 3.8 mm screws located near the bottom right and top left of the LCD base plate.

Step 9

  • Lift up silver LCD base plate

Lift up silver LCD base plate

Step 10

  • Using tweezers, lift up the retaining flap on the ZIF connector securing the button panel ribbon cable.
  • Slide the button panel ribbon cable out of its socket on the motherboard.

Using tweezers, lift up the retaining flap on the ZIF connector securing the button panel ribbon cable.

Slide the button panel ribbon cable out of its socket on the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    Shauna

Member since: 04/05/2011

774 Reputation

                                      5 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       Cal Poly, Team 12-32, Maness Spring 2011                        

                                                  Member of Cal Poly, Team 12-32, Maness Spring 2011 



                    CPSU-MANESS-S11S12G32                     


                                            4 Members                     


                                            10 Guides authored

danwat1234 - May 29, 2014

Reply

It would be nice to have a guide for replacing the flash capacitor.