Difficulty
Easy
Steps
6
Time Required
5 - 10 minutes
Sections
2
- Battery
- 2 steps
- Back Case
- 4 steps
Flags
0
BackNikon Coolpix S210
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Place thumb on the battery cover panel on the bottom of the device.
- Slide the panel to the right away from the camera.
Place thumb on the battery cover panel on the bottom of the device.
Slide the panel to the right away from the camera.
1024
Step 2
- Slide the orange latch outward towards the corner of the camera.
- The battery should pop out.
- Remove the battery and reattach the cover.
Slide the orange latch outward towards the corner of the camera.
The battery should pop out.
Remove the battery and reattach the cover.
Step 3
Back Case
- After removing the battery, unscrew the four 3.10mm screws on the side opposite the buttons.
After removing the battery, unscrew the four 3.10mm screws on the side opposite the buttons.
Step 4
- Unscrew the three 4.05mm screws on the bottom of the camera below the lens.
Unscrew the three 4.05mm screws on the bottom of the camera below the lens.
Step 5
- Unscrew the two 4.05mm screws on the side next to the buttons.
Unscrew the two 4.05mm screws on the side next to the buttons.
Step 6
- Gently wedge the flat end of the spudger between the back case and the wrist-strap mount.
- The wrist-strap mount is the thin metal piece on the side of the camera. Your camera may have the wrist-strap attached, but you will not need to remove it to continue.
- Carefully pry the back case away from the camera and then gently lift it off.
Gently wedge the flat end of the spudger between the back case and the wrist-strap mount.
The wrist-strap mount is the thin metal piece on the side of the camera. Your camera may have the wrist-strap attached, but you will not need to remove it to continue.
Carefully pry the back case away from the camera and then gently lift it off.
To reassemble your device, follow these instructions in reverse order, paying careful attention to the locations of the different sizes of screws.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 6 other contributors
Paul Doyle
Member since: 01/20/2011
480 Reputation
3 Guides authored
Badges:
11
+8 more badges
Team
Cal Poly, Team 5-17, Amido Winter 2011
Member of Cal Poly, Team 5-17, Amido Winter 2011
CPSU-AMIDO-W11S5G17
6 Members
12 Guides authored
danwat1234 - May 29, 2014
Reply
What about the front case so I can replace the flash board on top?