Nikon Coolpix P510 Lcd Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          2 - 5 minutes

Sections

Battery Removal
2 steps
LCD Screen Window
3 steps
LCD
3 steps

Flags

BackNikon Coolpix P510
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery Removal

Flip the camera over and push the tab on the battery cover to open the battery compartment.

Flip the camera over and push the tab on the battery cover to open the battery compartment.

1024

Step 2

Push the little yellow tab to allow the battery to slide out.
With the tab pushed out, pull the battery out.

Push the little yellow tab to allow the battery to slide out.

With the tab pushed out, pull the battery out.

Step 3

              LCD Screen Window

Extend the LCD screen out and turn the camera upside down to get access to the screws on the bottom.

Extend the LCD screen out and turn the camera upside down to get access to the screws on the bottom.

Step 4

Take the four 4mm PH00 Phillips screws out.

Take the four 4mm PH00 Phillips screws out.

Step 5

Use a plastic opening tool to trace around the screen to pop the front and back section apart.

Use a plastic opening tool to trace around the screen to pop the front and back section apart.

Step 6

LCD

Tilt the LCD up to get access to the back of it.

Tilt the LCD up to get access to the back of it.

Step 7

Unplug the ribbon cables on the side of the chip under the LCD by simple pulling lightly on them.

Unplug the ribbon cables on the side of the chip under the LCD by simple pulling lightly on them.

Step 8

The chip has an adhesive on it to keep it attached to the LCD, and you will need to use a plastic opening tool to get it off.
It may take a little bit of pressure to get the chip off. Be gentle to make sure you don’t break the chip.

The chip has an adhesive on it to keep it attached to the LCD, and you will need to use a plastic opening tool to get it off.

It may take a little bit of pressure to get the chip off. Be gentle to make sure you don’t break the chip.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 4 other contributors

                    Brian Hulsey

Member since: 03/31/2015

1,410 Reputation

                                      6 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Colorado Springs, Team 2-2, Panko Spring 2015                        

                                                  Member of Colorado Springs, Team 2-2, Panko Spring 2015 



                    UCCS-PANKO-S15S2G2                     


                                            3 Members                     


                                            12 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team