Difficulty

Moderate

Steps

6

Time Required

                          45 minutes - 1 hour

Sections

2

  • Plastic Cover
  • 4 steps
  • LCD Screen
  • 2 steps

Flags

0

  • BackNikon Coolpix L610

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Plastic Cover
  • Remove the four (3.20 mm) Phillips #00 screws at the bottom of the device.

Remove the four (3.20 mm) Phillips #00 screws at the bottom of the device.

1024

Step 2

  • Remove the top (4.10 mm) Phillips #00 screw adjacent to the battery compartment.
  • Remove the bottom (3.20 mm) Phillips #00 screw adjacent to the battery compartment.

Remove the top (4.10 mm) Phillips #00 screw adjacent to the battery compartment.

Remove the bottom (3.20 mm) Phillips #00 screw adjacent to the battery compartment.

Step 3

  • Remove the top (4.20 mm) Phillips #00 screw adjacent to the mic side of the camera and opposite the battery side.
  • Remove the lower (3.20 mm) Phillips #00 screw adjacent to the mic side of the camera and opposite of the battery side.

Remove the top (4.20 mm) Phillips #00 screw adjacent to the mic side of the camera and opposite the battery side.

Remove the lower (3.20 mm) Phillips #00 screw adjacent to the mic side of the camera and opposite of the battery side.

Step 4

  • Separate the case using the plastic prying tool. This can be done by placing the tool in the position that is shown and in the position on the left side of the camera.

Separate the case using the plastic prying tool. This can be done by placing the tool in the position that is shown and in the position on the left side of the camera.

Step 5

              Removing the screen
  • Using a prying tool, carefully lift up the LCD screen but do NOT pull it off.

Using a prying tool, carefully lift up the LCD screen but do NOT pull it off.

Step 6

              Removing the LCD Screen Ribbon
  • While the LCD screen is loose and unattached, there is a latch that is holding the ribbon in place. Slide the latch down and pull the ribbon out.

While the LCD screen is loose and unattached, there is a latch that is holding the ribbon in place. Slide the latch down and pull the ribbon out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Jeremy

Member since: 01/21/2015

982 Reputation

                                      5 Guides authored                  



                       Badges:
                       18







                                                        +15 more badges

Team

                       USF Tampa, Team 9-4, Brown Winter 2015                        

                                                  Member of USF Tampa, Team 9-4, Brown Winter 2015 



                    USFT-BROWN-W15S9G4                     


                                            4 Members                     


                                            12 Guides authored