Difficulty
Moderate
Steps
8
Time Required
20 - 40 minutes
Sections
1
- Screen
- 8 steps
Flags
0
BackNikon Coolpix
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
The screen is a vital part of the camera, it shows a preview of images and allows easy access to them. A faulty or damaged screen greatly hinders the usability of the camera. A simple repair such as this can extend the life of the camera to be used again or repurposed.
Before starting the repair, test your camera to see if it still turns on with a new pair of batteries to make sure that the screen is the only fix needed.
What you need
Step 1
Screen
- Undo the latch at the bottom of the camera by pushing it to the side
- Remove the batteries (and memory card if applicable)
Undo the latch at the bottom of the camera by pushing it to the side
Remove the batteries (and memory card if applicable)
1024
Step 2
- Remove the two 5 mm Phillips #000 screws from the left side.
Remove the two 5 mm Phillips #000 screws from the left side.
Step 3
- Lift the cover labeled “A/V OUT” to expose a hidden screw.
- Remove two 5 mm Phillips #000 screws from the bottom of the camera.
Lift the cover labeled “A/V OUT” to expose a hidden screw.
Remove two 5 mm Phillips #000 screws from the bottom of the camera.
Step 4
- Remove the two 5 mm Phillips #000 screws from the right side of the camera.
Remove the two 5 mm Phillips #000 screws from the right side of the camera.
Step 5
- Carefully pry the back cover starting from the battery latch.
- Once all sides are loose, lift the back cover up and off.
Carefully pry the back cover starting from the battery latch.
Once all sides are loose, lift the back cover up and off.
Step 6
- Carefully lift the LCD screen up towards the bottom of the camera.
- The LCD is connected to a cable so don’t pull it out yet.
Carefully lift the LCD screen up towards the bottom of the camera.
The LCD is connected to a cable so don’t pull it out yet.
Step 7
- Lightly push back the white switch holding in the screen cable
Lightly push back the white switch holding in the screen cable
Step 8
- Remove the cable from the camera.
- Lift the screen out.
Remove the cable from the camera.
Lift the screen out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Vishalpreet Sandhu
Member since: 01/18/2022
157 Reputation
1 Guide authored
Badges:
2
Team
York University, Team R-25, Melo-Thaiss Winter 2022
Member of York University, Team R-25, Melo-Thaiss Winter 2022
YORK-MELO-THAISS-W22SRG25
1 Member
1 Guide authored
