Difficulty
Moderate
Steps
7
Time Required
10 minutes
Sections
1
- Back Cover
- 7 steps
Flags
0
BackNikon Coolpix L26
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Remove the batteries from the battery compartment by sliding the white battery compartment switch up and then move the panel toward the right.
Remove the batteries from the battery compartment by sliding the white battery compartment switch up and then move the panel toward the right.
1024
Step 2
- Using the Phillips #000 screwdriver, unscrew the two 2mm screws next to the battery compartment on the right side of the camera.
Using the Phillips #000 screwdriver, unscrew the two 2mm screws next to the battery compartment on the right side of the camera.
Step 3
- Unscrew the two 2mm screws on the opposite side.
Unscrew the two 2mm screws on the opposite side.
Step 4
- Flip over the rubber AV cover at the bottom of the camera. Unscrew the last two 2mm screws on the bottom of the camera.
Flip over the rubber AV cover at the bottom of the camera. Unscrew the last two 2mm screws on the bottom of the camera.
Step 5
- Using your hands, open the camera slightly by using the indentation above the camera compartment.
Using your hands, open the camera slightly by using the indentation above the camera compartment.
Step 6
- Wedge the flat end of the spudger in between the front and back cover. Carefully push the spudger downward, which will lift the back cover off the camera.
Wedge the flat end of the spudger in between the front and back cover. Carefully push the spudger downward, which will lift the back cover off the camera.
Step 7
- Gently pull the cover off the camera.
Gently pull the cover off the camera.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 4 other contributors
Sadie
Member since: 02/16/2015
403 Reputation
3 Guides authored
Badges:
11
+8 more badges
Team
San Diego State, Team 1-3, Sheppard Winter 2015
Member of San Diego State, Team 1-3, Sheppard Winter 2015
SDSU-SHEPPARD-W15S1G3
2 Members
6 Guides authored
brendadawsonitp - Dec 21, 2017
Reply
my battery compartment will not close. can I buy a new one
srfrjoe57 - Jan 5, 2018
Reply
Thanks. I appreciate the help, but… The pin seems to be the toughest item to remove. You didn’t get that far.
This worked for the pin. I’m guessing it pushes through the front of the body behind the screen. I didn’t get that far. It for sure will not pull out of the back. I cut the pin and pulled it out (yes it did damage the plastic). I cut a small nail (brad) the put it through the cover and placed the brad in where the old pin was and placed a bit of super glue on it to hold it in place (don’t get any on the new cover). In a while I will assemble the camera and add more super glue. Yes, the super glue will be visible, but it will take some searching to find it and will look much better that a tie-wrap or tape. I hope that helps.