Difficulty

Moderate

Steps

8

Time Required

                          15 minutes

Sections

3

  • Battery
  • 4 steps
  • Front Panel
  • 2 steps
  • Shutter Button
  • 2 steps

Flags

0

  • BackNikon Coolpix AW130

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Using your thumb and pointer finger, open the card/battery hatch by pressing the center button of the wheel and turning the entire wheel to the left.
  • When reassembling, you must turn this wheel to the right until it clicks.

Using your thumb and pointer finger, open the card/battery hatch by pressing the center button of the wheel and turning the entire wheel to the left.

When reassembling, you must turn this wheel to the right until it clicks.

1024

Step 2

  • You should feel the door begin to loosen. Carefully pull the hatch open.

You should feel the door begin to loosen. Carefully pull the hatch open.

Step 3

  • Push the yellow battery/charger compartment tab up using your thumb nail.

Push the yellow battery/charger compartment tab up using your thumb nail.

Step 4

  • After pressing the yellow tab, the battery should loosen.
  • Slowly pull the battery completely out.

After pressing the yellow tab, the battery should loosen.

Slowly pull the battery completely out.

Step 5

              Front Panel
  • Using the T4 Torx Screwdriver, remove the 2, 4mm screws holding the N-Mark plate in place.
  • Carefully pull the plate off of the face.

Using the T4 Torx Screwdriver, remove the 2, 4mm screws holding the N-Mark plate in place.

Carefully pull the plate off of the face.

Step 6

  • Using the metal spudger tool, pry the colored face from the camera body.
  • Avoid bending or scratching the front face.

Using the metal spudger tool, pry the colored face from the camera body.

Avoid bending or scratching the front face.

Step 7

              Shutter Button
  • Using your thumb, separate the top piece of plastic from the camera.
  • If this piece does not come loose easily, try using the nylon spudger.

Using your thumb, separate the top piece of plastic from the camera.

If this piece does not come loose easily, try using the nylon spudger.

Step 8

  • Using tweezers from the precision tweezer set, carefully loosen the shutter button.
  • Atop the camera, there are two buttons. The shutter button should be the largest of the two.

Using tweezers from the precision tweezer set, carefully loosen the shutter button.

Atop the camera, there are two buttons. The shutter button should be the largest of the two.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor 


                    Lauren Stepp

Member since: 01/29/2016

1,251 Reputation

                                      8 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges

Team

                       Western Carolina University, Team 1-4, Virtue Spring 2016                        

                                                  Member of Western Carolina University, Team 1-4, Virtue Spring 2016 



                    WCU-VIRTUE-S16S1G4                     


                                            5 Members                     


                                            16 Guides authored