Difficulty
Moderate
Steps
7
Time Required
10 minutes
Sections
2
- Battery
- 4 steps
- Map/Wi-Fi/Action Buttons
- 3 steps
Flags
0
BackNikon Coolpix AW130
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Using your thumb and pointer finger, open the card/battery hatch by pressing the center button of the wheel and turning the entire wheel to the left.
- When reassembling, you must turn this wheel to the right until it clicks.
Using your thumb and pointer finger, open the card/battery hatch by pressing the center button of the wheel and turning the entire wheel to the left.
When reassembling, you must turn this wheel to the right until it clicks.
1024
Step 2
- You should feel the door begin to loosen. Carefully pull the hatch open.
You should feel the door begin to loosen. Carefully pull the hatch open.
Step 3
- Push the yellow battery/charger compartment tab up using your thumb nail.
Push the yellow battery/charger compartment tab up using your thumb nail.
Step 4
- After pressing the yellow tab, the battery should loosen.
- Slowly pull the battery completely out.
After pressing the yellow tab, the battery should loosen.
Slowly pull the battery completely out.
Step 5
Map/Wi-Fi/Action Buttons
- Using the spudger, pry the plastic button face from the camera body.
- The sharp edges of the spudger could cut you or pierce an exposed battery.
Using the spudger, pry the plastic button face from the camera body.
The sharp edges of the spudger could cut you or pierce an exposed battery.
Step 6
- Using tweezers from the precision tweezer set, remove the buttons from the larger plastic piece.
Using tweezers from the precision tweezer set, remove the buttons from the larger plastic piece.
Step 7
- Using tweezers from the precision tweezer set, remove the silicon backing from the buttons.
- From there, the buttons should dislodge from their plastic casing.
Using tweezers from the precision tweezer set, remove the silicon backing from the buttons.
From there, the buttons should dislodge from their plastic casing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Lauren Stepp
Member since: 01/29/2016
1,251 Reputation
8 Guides authored
Badges:
15
+12 more badges
Team
Western Carolina University, Team 1-4, Virtue Spring 2016
Member of Western Carolina University, Team 1-4, Virtue Spring 2016
WCU-VIRTUE-S16S1G4
5 Members
16 Guides authored