Difficulty

Moderate

Steps

6

Time Required

                          10 - 15 minutes

Sections

1

  • LCD
  • 6 steps

Flags

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

  • BackNikon Coolpix 995

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              LCD
  • Turn the lens/flash assembly 90 degrees, until you see the two Phillips #00 screws,
  • Remove the two screws with a Phillips #00 screwdriver.
  • Flip the flash so that you can access the remaining two screws. Remove these screws following the same method as before.
  • Refer to the second image to locate the second set of screws. The relevant screws are highlighted in red.

Turn the lens/flash assembly 90 degrees, until you see the two Phillips #00 screws,

Remove the two screws with a Phillips #00 screwdriver.

Flip the flash so that you can access the remaining two screws. Remove these screws following the same method as before.

Refer to the second image to locate the second set of screws. The relevant screws are highlighted in red.

1024

Step 2

  • Flip the camera up-side down.
  • Remove the two Phillips #00 screws located near the battery compartment.

Flip the camera up-side down.

Remove the two Phillips #00 screws located near the battery compartment.

Step 3

  • Open the memory card compartment cover.
  • You can now see four screws under the cover. Remove all four screws.
  • Refer to the image to locate the four screws. Make sure that you remove only the four screws identified in the image.

Open the memory card compartment cover.

You can now see four screws under the cover. Remove all four screws.

Refer to the image to locate the four screws. Make sure that you remove only the four screws identified in the image.

Step 4

  • Use your thumb to carefully lift the bottom side of the casing near the battery.
  • Pay attention to a cable located at the top of the assembly, as it is prone to breakage. Refer to the second image to locate the cable.

Use your thumb to carefully lift the bottom side of the casing near the battery.

Pay attention to a cable located at the top of the assembly, as it is prone to breakage. Refer to the second image to locate the cable.

Step 5

  • Use a spudger to flip the tabs that hold the screen.
  • Refer to the image for more details. The tabs are circled in red.

Use a spudger to flip the tabs that hold the screen.

Refer to the image for more details. The tabs are circled in red.

Step 6

  • Carefully lift the LCD from the bottom. It should come out fairly easily.

Carefully lift the LCD from the bottom. It should come out fairly easily.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 13 other contributors 


                    Cory Layman

Member since: 10/04/2011

89 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       UW Stout, Team 1-5, Zhou Fall 2011                        

                                                  Member of UW Stout, Team 1-5, Zhou Fall 2011 



                    UWSTOUT-ZHOU-F11S1G5                     


                                            5 Members                     


                                            6 Guides authored