Difficulty
Moderate
Steps
8
Time Required
15 minutes
Sections
1
- Battery Door
- 8 steps
Flags
0
BackNikon Coolpix 5400
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
The back housing must be removed to access the press fit pin holding the battery door.
Be careful not to drop the press fit pin into the body of the camera when removing with the tweezers.
A flat head screwdriver, a Phillips #0 screwdrivers, tweezers, and a plastic opening tool are required for this replacement.
Remove the battery before beginning any work to prevent electrical shock.
What you need
Step 1
Battery Door
- Remove one 3mm Phillips #0 screw from the top of the camera back cover.
Remove one 3mm Phillips #0 screw from the top of the camera back cover.
1024
Step 2
- Remove three 3mm Phillips #0 screws from the side of the back cover.
Remove three 3mm Phillips #0 screws from the side of the back cover.
Step 3
- Lift memory card flap.
- Remove one 3mm Phillips #0 screw from the side of the back case.
Lift memory card flap.
Remove one 3mm Phillips #0 screw from the side of the back case.
Step 4
- Remove four 3mm Phillips #0 screws from the bottom of the back case.
Remove four 3mm Phillips #0 screws from the bottom of the back case.
Step 5
- Use a plastic opening tool to gently pop the back case away from the body of the camera.
- Pull the back case away from the camera very gently.
- The connecting cables are very fragile and easily broken.
Use a plastic opening tool to gently pop the back case away from the body of the camera.
Pull the back case away from the camera very gently.
The connecting cables are very fragile and easily broken.
Step 6
- Flip camera over so the bottom is facing up.
- Push the sliding latch to open the battery door.
- Push the press fit pin firmly with a flat-head screwdriver to release it from the hinge housing.
- Push to the left, half the length of the pin.
Flip camera over so the bottom is facing up.
Push the sliding latch to open the battery door.
Push the press fit pin firmly with a flat-head screwdriver to release it from the hinge housing.
Push to the left, half the length of the pin.
Step 7
- Grasp the press fit pin firmly with precision tweezers to pull it from the housing.
- Do not to drop the pin into the camera body.
Grasp the press fit pin firmly with precision tweezers to pull it from the housing.
Do not to drop the pin into the camera body.
Step 8
- Remove the battery door by lifting it out of the camera body.
Remove the battery door by lifting it out of the camera body.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Savanah Cosand
Member since: 04/04/2019
303 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
Oregon Institute of Technology, Team S1-G4, Lancaster Spring 2019
Member of Oregon Institute of Technology, Team S1-G4, Lancaster Spring 2019
OIT-LANCASTER-S19S1G4
4 Members
6 Guides authored