Difficulty

Moderate

Steps

10

Time Required

                          20 minutes

Sections

1

  • Back Cover
  • 10 steps

Flags

0

  • BackNikon Coolpix 5400

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Remove one 3.0mm Phillips #0 screw from the top of the case.

Remove one 3.0mm Phillips #0 screw from the top of the case.

1024

Step 2

  • Remove two 3.0mm Phillips #0 screws from the card reader side of the case.

Remove two 3.0mm Phillips #0 screws from the card reader side of the case.

Step 3

  • Remove four 3.0mm Phillips #0 screws from the bottom of the camera.

Remove four 3.0mm Phillips #0 screws from the bottom of the camera.

Step 4

  • Remove one 3.0mm Phillips #0 screw from the side of the camera.

Remove one 3.0mm Phillips #0 screw from the side of the camera.

Step 5

  • Use a plastic opening tool to gently remove the back case from the rest of the camera.

Use a plastic opening tool to gently remove the back case from the rest of the camera.

Step 6

  • Pull the back of the camera cover apart.
  • Connecting wires that are still attached to the back cover are fragile.

Pull the back of the camera cover apart.

Connecting wires that are still attached to the back cover are fragile.

Step 7

  • Remove the two 4.0mm Phillips #0 screws holding the circuit board to the back case.

Remove the two 4.0mm Phillips #0 screws holding the circuit board to the back case.

Step 8

  • Pull the LCD screen cables in the direction that the wires are exiting the circuit board.
  • Pull the wire connector gently, the plastic is very fragile.

Pull the LCD screen cables in the direction that the wires are exiting the circuit board.

Pull the wire connector gently, the plastic is very fragile.

Step 9

  • Pull the toggle wheel wire connector up and away from the top of the camera.
  • Pull the button control panel wire connector up and away from the top of the camera.
  • Gently remove the wire connectors; the plastic is fragile.

Pull the toggle wheel wire connector up and away from the top of the camera.

Pull the button control panel wire connector up and away from the top of the camera.

Gently remove the wire connectors; the plastic is fragile.

Step 10

  • Remove the six 3.0mm Phillips #0 screws holding the button control panel.
  • Remove the back cover from the camera body.

Remove the six 3.0mm Phillips #0 screws holding the button control panel.

Remove the back cover from the camera body.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Rhett Myers

Member since: 04/05/2019

231 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Oregon Institute of Technology, Team S1-G4, Lancaster Spring 2019                        

                                                  Member of Oregon Institute of Technology, Team S1-G4, Lancaster Spring 2019 



                    OIT-LANCASTER-S19S1G4                     


                                            4 Members                     


                                            6 Guides authored