Difficulty
Moderate
Steps
7
Time Required
10 - 15 minutes
Sections
2
- Battery
- 1 step
- Front Cover
- 6 steps
Flags
1
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
BackNikon Coolpix 3500
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Unlatch the battery cover. Slide the cover out and flip it open.
- Remove the battery.
- Gently remove the battery cover.
Unlatch the battery cover. Slide the cover out and flip it open.
Remove the battery.
Gently remove the battery cover.
1024
Step 2
Front Cover
- Remove the two 4.5 mm screws that sit next to the battery slot.
- Remove the 3 mm screw that sits below the CF card slot.
- Remove the 4.5 mm screw that sits above the digital I/O cover.
Remove the two 4.5 mm screws that sit next to the battery slot.
Remove the 3 mm screw that sits below the CF card slot.
Remove the 4.5 mm screw that sits above the digital I/O cover.
Step 3
- Remove the two 4.5 mm screws that sit inside the battery slot.
Remove the two 4.5 mm screws that sit inside the battery slot.
Step 4
- Remove the two 5 mm screws that sit near the camera strap eyelet.
- Remove the camera strap eyelet.
Remove the two 5 mm screws that sit near the camera strap eyelet.
Remove the camera strap eyelet.
Step 5
- Remove the 5 mm screw and cap that were underneath the camera strap eyelet.
Remove the 5 mm screw and cap that were underneath the camera strap eyelet.
Step 6
- Remove the five 3.5 mm screws that sit at the bottom of the camera.
- Remove the grey plastic piece, which the five screws held in place, by gently detaching the front cover.
- Do not apply too much force; two wires still connect the front cover to the motherboard.
Remove the five 3.5 mm screws that sit at the bottom of the camera.
Remove the grey plastic piece, which the five screws held in place, by gently detaching the front cover.
Do not apply too much force; two wires still connect the front cover to the motherboard.
Step 7
- Using a spudger, detach the white-capped wire.
- Using a spudger, detach the orange-capped wire and set the front cover aside.
Using a spudger, detach the white-capped wire.
Using a spudger, detach the orange-capped wire and set the front cover aside.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
richard guenther
Member since: 04/19/2010
183 Reputation
6 Guides authored
Badges:
6
+3 more badges
Team
Cal Poly, Team 30-38, Garner Spring 2010
Member of Cal Poly, Team 30-38, Garner Spring 2010
CPSU-GARNER-S10S30G38
5 Members
11 Guides authored