Difficulty

Moderate

Steps

8

Time Required

                          10 minutes

Sections

3

  • External Case
  • 2 steps
  • Screen
  • 4 steps
  • Motherboard
  • 2 steps

Flags

0

  • BackNike+ Sportband

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              External Case
  • To begin the disassembly of your NikePlus Sportband, first remove the device from the rubber wristband.

To begin the disassembly of your NikePlus Sportband, first remove the device from the rubber wristband.

1024

Step 2

  • Finish the disassembly of your NikePlus Sportband by utilizing the metal spudger tool on the short edge to pry the external body pieces apart.

Finish the disassembly of your NikePlus Sportband by utilizing the metal spudger tool on the short edge to pry the external body pieces apart.

Step 3

              Screen
  • After the cover had been removed, use the metal spudger tool to remove the body of the device from the casing.

After the cover had been removed, use the metal spudger tool to remove the body of the device from the casing.

Step 4

  • Use the metal tweezers to pry the screen casing from the body of the device.
  • The screen casing is fastened to the body of the device by four clips located in each corner of the casing.

Use the metal tweezers to pry the screen casing from the body of the device.

The screen casing is fastened to the body of the device by four clips located in each corner of the casing.

Step 5

  • Flip the body of the device over so that the screen is now on the bottom.
  • The display ribbon cable is soldered to the motherboard. We were able to peel up the ribbon cable with a pair of tweezers.
  • Successfully resoldering this ribbon cable to the motherboard may prove difficult to the very small traces.

Flip the body of the device over so that the screen is now on the bottom.

The display ribbon cable is soldered to the motherboard. We were able to peel up the ribbon cable with a pair of tweezers.

Successfully resoldering this ribbon cable to the motherboard may prove difficult to the very small traces.

Step 6

  • Flip the body of the device back over so that the screen is facing up.
  • Using the tweezers, gently lift the screen from body of the device.

Flip the body of the device back over so that the screen is facing up.

Using the tweezers, gently lift the screen from body of the device.

Step 7

              Motherboard
  • Remove the four highlighted screws from the motherboard using the Philips screwdriver.

Remove the four highlighted screws from the motherboard using the Philips screwdriver.

Step 8

  • Use the metal tweezers to lift the motherboard out of the device.

Use the metal tweezers to lift the motherboard out of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Alyssa Setnar

Member since: 02/15/2016

331 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       IUPUI, Team 9-9, Wilson Spring 2016                        

                                                  Member of IUPUI, Team 9-9, Wilson Spring 2016 



                    IUPUI-WILSON-S16S9G9                     


                                            5 Members                     


                                            4 Guides authored