Difficulty

Moderate

Steps

12

Time Required

                          20 - 30 minutes

Sections

4

  • Rear Cover
  • 2 steps
  • Battery
  • 2 steps
  • Battery Housing
  • 6 steps
  • Secondary Microphone
  • 2 steps

Flags

1

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackNexus One

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Rear Cover
  • Using two fingers, push up on the rear cover.

Using two fingers, push up on the rear cover.

1024

Step 2

  • The rear cover slides up and off.

The rear cover slides up and off.

Step 3

              Battery
  • Using the plastic opening tools, pry the left bottom corner of the battery up.

Using the plastic opening tools, pry the left bottom corner of the battery up.

Step 4

  • Pull the battery up and out.

Pull the battery up and out.

Step 5

              Battery Housing
  • Remove the two Torx T5 screws.
  • Remove the one Philips #00 screw.

Remove the two Torx T5 screws.

Remove the one Philips #00 screw.

Step 6

  • Using the plastic opening tool, pry up the battery housing upwards.
  • Push pry tool down, undoing the plastic tab.

Using the plastic opening tool, pry up the battery housing upwards.

Push pry tool down, undoing the plastic tab.

Step 7

  • Pry the upper left tab open on the battery housing.

Pry the upper left tab open on the battery housing.

Step 8

  • Pry the top tab of the battery housing.

Pry the top tab of the battery housing.

Step 9

  • Pry the right side tab of the battery housing.

Pry the right side tab of the battery housing.

Step 10

  • Pull up on the battery housing.
  • Slide the battery housing out to remove it.

Pull up on the battery housing.

Slide the battery housing out to remove it.

Step 11

              Secondary Microphone
  • Using the spudger, pry upwards on the second microphone connector.

Using the spudger, pry upwards on the second microphone connector.

Step 12

  • Pull up on the ribbon cable, the tape will detach from the main board ribbon.

Pull up on the ribbon cable, the tape will detach from the main board ribbon.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Niklas Johnson

Member since: 01/31/2012

1,207 Reputation

                                      18 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges