Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

3

  • Rear Case
  • 1 step
  • Vibrator Daughterboard
  • 4 steps
  • Vibrator
  • 1 step

Flags

0

  • BackNexus 9

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear Case
  • With your fingers, carefully pry off the back plastic casing. Starting at the corners is usually the easiest.
  • The rear-facing camera seems to fit a little too snugly in its compartment on the rear case; so make sure that it stays connected to the motherboard.

With your fingers, carefully pry off the back plastic casing. Starting at the corners is usually the easiest.

The rear-facing camera seems to fit a little too snugly in its compartment on the rear case; so make sure that it stays connected to the motherboard.

1024

Step 2

              Vibrator Daughterboard
  • Disconnect the two ZIF connectors attached to the daughterboards.
  • Gently pull on the ribbon cable to remove it.

Disconnect the two ZIF connectors attached to the daughterboards.

Gently pull on the ribbon cable to remove it.

Step 3

  • Remove the two 3mm T5 Torx screws securing the metal USB port bracket.
  • Use your fingers or a pair of tweezers to remove the bracket.

Remove the two 3mm T5 Torx screws securing the metal USB port bracket.

Use your fingers or a pair of tweezers to remove the bracket.

Step 4

  • Unscrew the two 3mm T5 Torx screws securing the daughterboard to the device.
  • Use a pair of tweezers to disconnect the vibrator cable. It will lift straight up from the daughterboard connector.
  • Use your fingers to lift the daughterboard upward and out of the device.

Unscrew the two 3mm T5 Torx screws securing the daughterboard to the device.

Use a pair of tweezers to disconnect the vibrator cable. It will lift straight up from the daughterboard connector.

Use your fingers to lift the daughterboard upward and out of the device.

Step 5

  • The daughterboard has an orange ribbon cable that is adhered to the device. Gently pull the ribbon up and remove the daughtboard.

The daughterboard has an orange ribbon cable that is adhered to the device. Gently pull the ribbon up and remove the daughtboard.

Step 6

              Vibrator
  • Use a pair of tweezers to remove the vibrator from the device.

Use a pair of tweezers to remove the vibrator from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Geoff Wacker

Member since: 09/30/2013

87,546 Reputation

                                      89 Guides authored                  



                       Badges:
                       44







                                                        +41 more badges