Difficulty
Moderate
Steps
5
Time Required
Suggest a time??
Sections
2
- Rear Case
- 1 step
- Vibrator Daughterboard
- 4 steps
Flags
0
BackNexus 9
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Case
- With your fingers, carefully pry off the back plastic casing. Starting at the corners is usually the easiest.
- The rear-facing camera seems to fit a little too snugly in its compartment on the rear case; so make sure that it stays connected to the motherboard.
With your fingers, carefully pry off the back plastic casing. Starting at the corners is usually the easiest.
The rear-facing camera seems to fit a little too snugly in its compartment on the rear case; so make sure that it stays connected to the motherboard.
1024
Step 2
Vibrator Daughterboard
- Disconnect the two ZIF connectors attached to the daughterboards.
- Gently pull on the ribbon cable to remove it.
Disconnect the two ZIF connectors attached to the daughterboards.
Gently pull on the ribbon cable to remove it.
Step 3
- Remove the two 3mm T5 Torx screws securing the metal USB port bracket.
- Use your fingers or a pair of tweezers to remove the bracket.
Remove the two 3mm T5 Torx screws securing the metal USB port bracket.
Use your fingers or a pair of tweezers to remove the bracket.
Step 4
- Unscrew the two 3mm T5 Torx screws securing the daughterboard to the device.
- Use a pair of tweezers to disconnect the vibrator cable. It will lift straight up from the daughterboard connector.
- Use your fingers to lift the daughterboard upward and out of the device.
Unscrew the two 3mm T5 Torx screws securing the daughterboard to the device.
Use a pair of tweezers to disconnect the vibrator cable. It will lift straight up from the daughterboard connector.
Use your fingers to lift the daughterboard upward and out of the device.
Step 5
- The daughterboard has an orange ribbon cable that is adhered to the device. Gently pull the ribbon up and remove the daughtboard.
The daughterboard has an orange ribbon cable that is adhered to the device. Gently pull the ribbon up and remove the daughtboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
Geoff Wacker
Member since: 09/30/2013
87,546 Reputation
89 Guides authored
Badges:
44
+41 more badges