Difficulty
Moderate
Steps
4
Time Required
10 minutes
Sections
2
- SIM Card
- 1 step
- Rear Case
- 3 steps
Flags
0
BackNexus 6
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
SIM Card
- With a SIM card eject tool (a paperclip will work as well), push down on the hole at the top of the phone until the SIM card holder releases. This should not take much pressure.
- Remove the SIM card and the SIM card holder.
With a SIM card eject tool (a paperclip will work as well), push down on the hole at the top of the phone until the SIM card holder releases. This should not take much pressure.
Remove the SIM card and the SIM card holder.
1024
Step 2
Rear Case
- Lay out a soft cloth on your workspace to prevent scratching the screen in this and future steps.
- Pry open the back casing using the soft plastic opening pick.
- Be careful of the Power & Volume Key ribbon on the left side just next to the volume key. The ribbon is exposed and could be damaged with the opening tool.
- Carefully pull the back casing apart from the rest of the phone with your hands. Because the casing is glued to the rest of the phone, this step may require some force. Don’t be alarmed if the casing flexes a bit.
- You may need an iOpener to loosen up the adhesive. Check out the iOpener Instructions for info on how to use it.
Lay out a soft cloth on your workspace to prevent scratching the screen in this and future steps.
Pry open the back casing using the soft plastic opening pick.
Be careful of the Power & Volume Key ribbon on the left side just next to the volume key. The ribbon is exposed and could be damaged with the opening tool.
Carefully pull the back casing apart from the rest of the phone with your hands. Because the casing is glued to the rest of the phone, this step may require some force. Don’t be alarmed if the casing flexes a bit.
You may need an iOpener to loosen up the adhesive. Check out the iOpener Instructions for info on how to use it.
Step 3
- Remove the twenty-two 2.3 mm T3 Torx screws with the T3 Torx Screwdriver.
Remove the twenty-two 2.3 mm T3 Torx screws with the T3 Torx Screwdriver.
Step 4
- With tweezers, remove the rubber protector on the lower part of the phone.
- Disconnect the battery connector by gently prying it straight up with a spudger, on the side opposite the cable.
- Completely separate the battery side from the motherboard side by gently pulling the sides apart with your hands.
With tweezers, remove the rubber protector on the lower part of the phone.
Disconnect the battery connector by gently prying it straight up with a spudger, on the side opposite the cable.
Completely separate the battery side from the motherboard side by gently pulling the sides apart with your hands.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
6 other people completed this guide.
Author
with 9 other contributors
Marina Moore
Member since: 01/13/2015
4,284 Reputation
7 Guides authored
Badges:
16
+13 more badges
Team
Cal Poly, Team 70-3, Forte Winter 2015
Member of Cal Poly, Team 70-3, Forte Winter 2015
CPSU-FORTE-W15S70G3
4 Members
30 Guides authored