Difficulty
Easy
Steps
5
Time Required
Suggest a time??
Sections
2
- Back Cover
- 3 steps
- Docking Port
- 2 steps
Flags
1
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackNextbook Flexx 10
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- To begin, turn off the power to the device and remove the screen from the keyboard.
- Open the 2-in-1, and hold the screen.
- Press the silver button at the top of the keyboard.
- When the screen lifts up, gently lift the screen away from the keyboard.
To begin, turn off the power to the device and remove the screen from the keyboard.
Open the 2-in-1, and hold the screen.
Press the silver button at the top of the keyboard.
When the screen lifts up, gently lift the screen away from the keyboard.
1024
Step 2
- You may use your fingers, or a spudger. Be careful not to break your cover OR your fingernail. Removing the cover requires good judgement.
- The goal is to separate the black from the silver. Start in a corner, or a flat edge – whichever works best for you. Remember to not use too much force.
- Once you start the initial separation, keep going until you free one edge. The goal now is to free three edges of the rectangle.
- If your progress stops on one side of the rectangle, go to the other side and try there.
You may use your fingers, or a spudger. Be careful not to break your cover OR your fingernail. Removing the cover requires good judgement.
The goal is to separate the black from the silver. Start in a corner, or a flat edge – whichever works best for you. Remember to not use too much force.
Once you start the initial separation, keep going until you free one edge. The goal now is to free three edges of the rectangle.
If your progress stops on one side of the rectangle, go to the other side and try there.
Step 3
- Gently pull the back cover from the screen assembly.
- Keep the plastic cover close. It’s great for holding screws!
- When putting the cover back on, press firmly around to outside edge with the screen facing down on a flat, debris-free surface.
Gently pull the back cover from the screen assembly.
Keep the plastic cover close. It’s great for holding screws!
When putting the cover back on, press firmly around to outside edge with the screen facing down on a flat, debris-free surface.
Step 4
Docking Port
- Now, look around the outer edge in between the two speakers.
- Locate the docking port
- Remove the two screws holding the docking port in place with a PH0 philips head screwdriver.
Now, look around the outer edge in between the two speakers.
Locate the docking port
Remove the two screws holding the docking port in place with a PH0 philips head screwdriver.
Step 5
- After both screws are removed:
- Carefully lift the black part of the connector at the board end of the gold cable.
- Gently pull the gold cable out of the slot.
After both screws are removed:
Carefully lift the black part of the connector at the board end of the gold cable.
Gently pull the gold cable out of the slot.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 3 other contributors
Drew Walker
Member since: 09/08/2017
134 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
Western Carolina University, Team S1-G4, Virtue Fall 2017
Member of Western Carolina University, Team S1-G4, Virtue Fall 2017
WCU-VIRTUE-F17S1G4
5 Members
12 Guides authored
