Difficulty
Moderate
Steps
3
Time Required
10 minutes
Sections
1
- Pump Assembly
- 3 steps
Flags
0
BackNewport HT70/HT70+
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
For more information on replacing the pump assembly, please refer to page 5-20 in the service manual.
What you need
Step 1
Pump Assembly
- Position the base assembly so that you may access it.
- Using the #1 Phillips screwdriver, unscrew the four screws (SCR3219P in the photo) and the two screws (SCR3232P) securing the base plate.
Position the base assembly so that you may access it.
Using the #1 Phillips screwdriver, unscrew the four screws (SCR3219P in the photo) and the two screws (SCR3232P) securing the base plate.
1024
Step 2
- The base plate will then come apart from the rest of the device with the pump assembly attached to it, as depicted in the following photo.
- Inspect pump assembly for any damage or looseness.
The base plate will then come apart from the rest of the device with the pump assembly attached to it, as depicted in the following photo.
Inspect pump assembly for any damage or looseness.
Step 3
- If damage is found, replace the pump assembly by removing each tube individually and replacing as needed.
- You may not need to replace the entire assembly if parts of it are still intact.
If damage is found, replace the pump assembly by removing each tube individually and replacing as needed.
You may not need to replace the entire assembly if parts of it are still intact.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Merek McGill
Member since: 04/07/2020
520 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team S7-G5, Paton Spring 2020
Member of Cal Poly, Team S7-G5, Paton Spring 2020
CPSU-PATON-S20S7G5
3 Members
6 Guides authored