Difficulty

Easy

Steps

4

Time Required

                          5 - 15 minutes            

Sections

1

  • Network card
  • 4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackDell Latitude E5400

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove battery               
  • Be sure to remove the battery to prevent any electrical shortage.

Be sure to remove the battery to prevent any electrical shortage.

1024

Step 2

              Remove the backpanel               
  • Loosen all four screws and remove the back panel.
  • Remove the back panel with a spudger. Start out as in the second photo to prevent the plastic from breaking. Work you’re way around the panel to remove it.

Loosen all four screws and remove the back panel.

Remove the back panel with a spudger. Start out as in the second photo to prevent the plastic from breaking. Work you’re way around the panel to remove it.

Step 3

              Remove the antenna wires               
  • In the red circle is the network card
  • Remove the two wires (inside the green circle)
  • the wires are very fragile and need to be removed with care

In the red circle is the network card

Remove the two wires (inside the green circle)

the wires are very fragile and need to be removed with care

Step 4

              Remove the network card               
  • Place the spudger as shown in the photo. The network card will pop up. After that you can remove it and replace it with another one
  • The wires are very fragile, be aware!

Place the spudger as shown in the photo. The network card will pop up. After that you can remove it and replace it with another one

The wires are very fragile, be aware!

To reassemble your device, follow these instructions in reverse order. Be sure to connect the wires the same as in step 3.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Robin Koch                     

Member since: 03/25/2017

286 Reputation

                                      2 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges