Difficulty
Moderate
Steps
12
Time Required
15 minutes
Sections
3
- Lower Case
- 4 steps
- Motherboard
- 2 steps
- Antenna
- 6 steps
Flags
1
Featured Student Guide
This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.
BackNETGEAR WGT624 v3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Lower Case
- Turn the device so that the bottom is facing up.
Turn the device so that the bottom is facing up.
1024
Step 2
- Use the plastic opening tool to carefully lift the rubber stops in each corner.
- Do not completely remove the rubber stops, because they are difficult to replace.
Use the plastic opening tool to carefully lift the rubber stops in each corner.
Do not completely remove the rubber stops, because they are difficult to replace.
Step 3
- Unscrew the 4 11.8 mm T-8 Torx screws from each corner of the device.
Unscrew the 4 11.8 mm T-8 Torx screws from each corner of the device.
Step 4
- Lift the lower case straight up from the rest of the router.
Lift the lower case straight up from the rest of the router.
Step 5
Motherboard
- Remove the clear plastic casing by lifting it straight up from the router.
Remove the clear plastic casing by lifting it straight up from the router.
Step 6
- Separate the motherboard from the top shell by lifting it straight up from the router.
Separate the motherboard from the top shell by lifting it straight up from the router.
Step 7
Antenna
- Turn the motherboard, so that the top is facing upwards.
- Place the motherboard on a clean flat surface.
Turn the motherboard, so that the top is facing upwards.
Place the motherboard on a clean flat surface.
Step 8
- Remove the yellow tape that holds the wire.
- Make sure that you set the tape aside on a clean surface, so that it can be reused.
Remove the yellow tape that holds the wire.
Make sure that you set the tape aside on a clean surface, so that it can be reused.
Step 9
- Use tweezers to gently pull the metal bracket that connects the antenna to the motherboard.
- The wire should now be completely separate from the motherboard.
Use tweezers to gently pull the metal bracket that connects the antenna to the motherboard.
The wire should now be completely separate from the motherboard.
Step 10
- Extend the antenna away from the device, so that it becomes straight.
Extend the antenna away from the device, so that it becomes straight.
Step 11
- Find the clips that hold the antenna onto the router.
- Use one hand to push the clips in, while using your other hand to pull out the antenna. You may need to gently twist the antenna so it can separate from the hole.
- The antenna may take considerable force to remove.
Find the clips that hold the antenna onto the router.
Use one hand to push the clips in, while using your other hand to pull out the antenna. You may need to gently twist the antenna so it can separate from the hole.
The antenna may take considerable force to remove.
Step 12
- Completely separate the antenna and wire from the rest of the device.
Completely separate the antenna and wire from the rest of the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Jonathon Sather
Member since: 01/23/2013
45 Reputation
3 Guides authored
Badges:
5
+2 more badges
Team
Cal Poly, Team 3-31, Amido Winter 2013
Member of Cal Poly, Team 3-31, Amido Winter 2013
CPSU-AMIDO-W13S3G31
3 Members
6 Guides authored
