Netgear Arlo 2 Camera Hd Security System Case Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Case
5 steps

Flags

BackNetgear Arlo 2 Camera HD Security System
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Case

Unscrew the two 3.0 mm Phillips #00 screws on the bottom of the camera.
Open the battery compartment on the bottom by pushing the switch marked in orange to the side and pushing the bottom of the camera back, sliding it open.

Unscrew the two 3.0 mm Phillips #00 screws on the bottom of the camera.

Open the battery compartment on the bottom by pushing the switch marked in orange to the side and pushing the bottom of the camera back, sliding it open.

1024

Step 2

Remove the bottom piece of the case over the battery compartment by placing a plastic opening tool underneath the edge of the case and prying it up.
Unscrew the four 3.0 mm Phillips #00 screws on the outside of the battery pocket.

Remove the bottom piece of the case over the battery compartment by placing a plastic opening tool underneath the edge of the case and prying it up.

Unscrew the four 3.0 mm Phillips #00 screws on the outside of the battery pocket.

Step 3

When facing the camera lens, the left panel of the case will be removed first (more steps are needed for the right panel).
Place the plastic opening tool between the two pieces of the case and pry them apart from the bottom.
Gently pull the side of the case off as it comes loose.

When facing the camera lens, the left panel of the case will be removed first (more steps are needed for the right panel).

Place the plastic opening tool between the two pieces of the case and pry them apart from the bottom.

Gently pull the side of the case off as it comes loose.

Step 4

Unscrew the smaller 3.0 mm Phillips #00 screw in the center on the back of the device.
Flip the camera over and unscrew the center 3.0 mm Phillips #00 screw above the SYNC button.

Unscrew the smaller 3.0 mm Phillips #00 screw in the center on the back of the device.

Flip the camera over and unscrew the center 3.0 mm Phillips #00 screw above the SYNC button.

Step 5

Using the plastic opening tool, gently pry the right panel from the device.
Replace either side of the plastic case as needed.

Using the plastic opening tool, gently pry the right panel from the device.

Replace either side of the plastic case as needed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Katherine McCombs

Member since: 10/25/2018

469 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UMass Dartmouth, Team S2-G4, Peak Fall 2018                        

                                                  Member of UMass Dartmouth, Team S2-G4, Peak Fall 2018 



                    UMASSD-PEAK-F18S2G4                     


                                            3 Members                     


                                            10 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team