Difficulty
Easy
Steps
5
Time Required
1 minute
Sections
2
- Outer Case
- 3 steps
- Mounting Clips
- 2 steps
Flags
0
BackNest Dropcam Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outer Case
- Press in the mounting clips on each side of the case to remove the camera from the mount.
Press in the mounting clips on each side of the case to remove the camera from the mount.
1024
Step 2
- Using a Philips #0 screwdriver, remove the four 3 mm screws.
Using a Philips #0 screwdriver, remove the four 3 mm screws.
Step 3
- Lift the front of the case slowly, as there is an antenna cable attached to the motherboard.
- Carefully disconnect the antenna cable from the motherboard. You will feel this cable “pop” out of place when disconnected.
Lift the front of the case slowly, as there is an antenna cable attached to the motherboard.
Carefully disconnect the antenna cable from the motherboard. You will feel this cable “pop” out of place when disconnected.
Step 4
Mounting Clips
- Using a Philips #0 screwdriver, remove the four 4 mm screws that are attaching the mounting clips to the case.
Using a Philips #0 screwdriver, remove the four 4 mm screws that are attaching the mounting clips to the case.
Step 5
- Lift the mounting clips away from the case.
Lift the mounting clips away from the case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
David Foens
Member since: 09/03/2015
893 Reputation
6 Guides authored
Badges:
19
+16 more badges
Team
USF Tampa, Team 15-4, Blackwell Fall 2015
Member of USF Tampa, Team 15-4, Blackwell Fall 2015
USFT-BLACKWELL-F15S15G4
3 Members
12 Guides authored